STI -30104 Guia De Inicio Rapido

Time for lamp to stay on
Installation:
1. Unplug the existing lamp from the power wall outlet.
2. Plug the Lamp Controller into the power wall outlet.
3. Plug the lamp into the Lamp Controller. Match wide blade of
plug to wide slot and insert fully.
4. Plug the jack from the Lamp Controller into the back of a
Wireless Alert Series receiver (sold separately).
Operation:
1. Set the Lamp Controller mode; ON (manually turns the lamp
ON), Timer (activated by the receiver), or OFF (manually turns
the lamp OFF).
2. Set the time for the lamp to be turned ON each time the
receiver is activated, 2 minutes, 5 minutes, 10 minutes, or ∞
(turns on indefinitely until manually reset). To manually reset
the Lamp Controller, turn the timer switch to OFF then back
to TIMER.
3. The Red LED light turns on whenever the Lamp Controller is
powering the lamp. Note: The Lamp Controller is triggered
by a 3.5-12V DC, 1 second pulse. The jack is an 1/8 inch
mono audio plug (negative tip).
Safety Technology
International, Inc.
2306 Airport Road · Waterford, MI 48327
Phone: 248-673-9898 · Toll Free: 800-888-4784
Fax: 248-673-1246 · www.sti-usa.com
LAMP CONTROLLER
STI-30104
Mode
LED
This Lamp Controller will turn on a lamp
anytime your STI Wireless Alert Series
Receiver(s), with output, is triggered. Never
come home to a dark house again – and let
other 'think' you are home even if you are not.
Warnings:
FOR INDOOR USE ONLY. For use with 250 Watt or less
incandescent lamps.
CANNOT be used with 3-prong grounded plugs. When using
with a lamp, keep lamps away from bed coverings, curtains or
other materials which may present a fire hazard. Do not connect
to heaters or other heat-producing appliances.
Keep away from water and damp areas. To prevent electric
shock, match wide blade of plug to wide slot and fully insert end.
Limited Warranty:
Safety Technology International, Inc. warrants to the original consumer/purchaser
that this product shall be free of defects in material and workmanship under
normal use and circumstances for a period of one (1) year from the date of
original purchase for use.
One Year Limited Warranty
ETL Listed conforms to UL 8730-2-7
Certified to CAN/CSA-E730-2-7
Maximum Load: 250 watts incandescent lamp
Made in China
LAMP CONTROLLER 07-12