Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Place contents into drum. Make sure top sealing
edge of drum is free from debris, cuts or gouges.
NOTE: The lid gasket has been pre-lubed with
silicone during manufacturing. If desired,
additional silicone spray may be applied prior
to closing to aid the closure process.
2. Place lid on drum and twist the lid in a counter-
clockwise direction until the lid drops onto the drum.
3. Twist the lid in a clockwise direction until the lid is
tightened. Apply additional torque to continue
twisting the lid until the arrow on the side of the lid
matches up with ALIGN on the side of the drum.
(See Figure 1)
NOTE: If the arrow will not match up with some
portion of ALIGN, do not ship.
NOTE: The closure process may be performed
by hand or with the use of a substrate, such
as a 2 x 4". The substrate should be placed
between the slots on the lid to allow proper
torque to tighten the arrow to ALIGN.
4. It may be necessary to "snug" the lid before
shipment if the unit has been closed and has sat
awaiting disposal. This may move the arrow past
ALIGN.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
PAGE 2 OF 6
CLOSING INSTRUCTIONS
1-800-295-5510
uline.com
Figure 1
NOTE: Do not exceed limitations. Do not use
if the closure instructions cannot be properly
performed.
0919 IH-5067
Publicidad
