Publicidad
Idiomas disponibles
Idiomas disponibles
Step 1: Identify all parts packed in carton against the parts list. Remove protective materials and place parts on a flat, non-
abrasive surface to avoid scratching.
Step 2: Attach chair back (A) to the chair arm (C) by using the provided bolts (F) and washers (G). Guide each bolt and washer
through holes on the chair back to the chair arm as shown in diagram. Hand tighten 3 – 4 revolutions only. Attach the chair seat
(B) to the chair arm by using bolt (E) & washer, guide bolt and washer through holes on the chair seat to the chair arm, also
hand tighten only.
Step 3: Repeat the same procedure as Step 2 on the other side of the chair arm (D).
Step 4: Tighten all bolts with the Hex bolt driver (I) provided. Cover all bolt with the PVC
cover (H) provided. If you do not feel your chair is assembled properly, repeat step 2 and 3.
IF YOU HAVE QUESTIONS OR CONCERNS, PLEASE CALL BOND TOLL FREE # 1-866-711-BOND (2663)
OR TO BETTER EXPEDITE YOUR REQUEST FEEL FREE TO EMAIL US
customer.service@bondmfg.com
OR VISIT OUR WEBSITE UNDER CUSTOMER SERVICE SUPPORT
www.bondmfg.com
BOND MANUFACTURING CO.
1700 West 4
th
Street, Antioch, CA 94509
Page 2
Publicidad
