SPX OTC 1884 Lista De Piezas E Instrucciones De Montaje

Part
Item
No. No.
1 44135
2 440487
3 222479
4 46895
5 4004
6 9795
7 36886
CAUTION: To prevent personal injury or equipment damage,
•
The owner of the press is responsible for the press being installed and operated according to
federal (OSHA), state, and local safety standards.
•
Wear eye protection that meets ANSI Z87.1 and OSHA standards.
•
Read, understand, and follow all safety precautions and operating instructions included with the
press. Safety-related decals must be installed, maintained, and replaced if they become unreadable.
•
Keep hands out of the work area during a pressing operation.
•
Work pieces must be well supported and aligned so that ram force is straight, and parts being
pressed cannot slip out or break.
•
Locate the press in an isolated area or shield the press to minimize danger to others.
•
It is impossible for the manufacturer to provide practical "all-purpose" shielding because this is
a general purpose press that can be used in many different ways. The owner of the press must
provide shielding that is practical and necessary for each application. Some protection is
provided by wrapping the piece in a protective blanket before applying pressure. (Protective
blankets are offered in the OTC catalog.)
•
Do not stress adapters beyond their capacities; adapters used with this press must have a maximum tonnage
rating equal to or higher than the maximum tonnage rating of the press.
This press can exert an extremely high force at a moderate hydraulic pump pressure. If you have any questions
concerning an application, or how much force is exerted at a given pressure, please contact Technical Services.
1. Remove the pipe plug from the pump. Install the swivel connector and hose.
2. Position the pump on the bench or floor where it's convenient for the operator. Refer to the instructions included with
the pump for assembly information.
3. Thread the cylinder into the mounting plate until the cylinder threads are flush with
the bottom of the plate (full thread engagement.) Adjust the position of the cylinder
so the coupler faces the pump side of the press. Install the hose.
© SPX Corporation
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
Bench Press
Max. Capacity: 10 Tons
No.
Req'd
Description
1 10-Ton Cylinder
1 Press Frame
1 Decal
1 Warning Decal
1 Hydraulic Hand Pump
1 Quick Coupler Assembly
1 Hose Assembly
Safety Precautions
Assembly Instructions
Parts List &
Assembly Instructions for:
7
Sheet No.
Issue Date: Rev. B, 8-16-02
Form No. 102765
1884
6
1
2
3
4
5
1 of 1