Parts List - Reese Explore 63155 Guía De Instrucciones

ASSEMBLY INSTRUCTIONS

PARTS LIST

Tools required for assembly: 13mm wrench , 13mm
socket with ratchet, 19mm wrench, 19mm socket with
ratchet, torque wrench.
1
F
1/2" hitch pin
G
Hitch pin clip
Support tube
H
Hex lock nut M12 x 1.75
Assemble cargo basket. FIG. 1.
1. Place each half of cargo basket on a flat surface with the cargo mesh floor facing down as shown.
2. Slide the two halves together and attach the two steel end plates to the upright bars with the logo label facing the outside.
Use the M8 hex bolts, washers and lock nuts as shown (both sides). Tighten loosely at this time.
3. Place the support tube in between the two support rails on the bottom of the basket. Note, the support tube must be in the
rise position as shown.
4. Attach the tube to the bottom of the basket using the M12 hex bolts and lock nuts as shown.
5. Tighten all bolts. Torque the M12 bolts to 75 ft-lb. Torque the M8 bolts to 25 ft-lb.
PART
A
B
C
D
E
Steel end plate
I
B
Cargo Basket Half
J
PAGE 2
DESCRIPTION QTY.
Hex bolt M12 x 1.75 x 80mm 3
Hex lock nut M12 x 1.75 3
Hex bolt M8 x 1.25 x 20mm 8
Hex lock nut M8 x 1.25 8
M8 flat washer 8
Support rails
Upright bar
63155_Rev A • Questions? (800) 234-6992 • ReeseBrands.com
PART DESCRIPTION
F 1/2" hitch pin
G Hitch pin clip
H Support Tube
I Steel End Plate
J Cargo Basket Half
Hex bolt M12 x 1.75 x 80mm
A
D
Hex lock nut M8 x 1.25
M8 flat washer
Hex bolt M8 x 1.25 x 20mm
QTY.
1
1
1
2
2
E
C