Bluelab Probe Care Kits
The instrument is only as accurate as the probe is clean!
Probe cleaning is one of the most important parts of owning and operating any
Bluelab meter, monitor or controller. If the probe is contaminated (dirty) it aff ects
the accuracy of the reading displayed.
The probe surface is where the instrument takes the reading of the solution. The information is sent back
from the probe to the electronic brain of the instrument. A calculation is then done in the instrument's
brain or micro computer and a reading is displayed. If the information sent back from the probe is
inaccurate due to probe surface contamination then the reading will be inaccurate. Cleaning the probes is
a very easy task and will prolong the life of the probes.
Bluelab Probe Care Kit - pH
contents:
› Cleaning instructions inside box lid
› 500ml pH4 and pH7 Calibration solutions
› Decanter vessels
› Bluelab pH Probe Cleaner
› Toothbrush (probe cleaning instrument)
9
If you need assistance or advice - we're here to help you.
Phone: +64 7 578 0849
Email: support@getbluelab.com
Looking for specifi cations or technical advice?
Visit us online @ www.getbluelab.com
Bluelab Corporation Limited
8 Whiore Avenue, Tauriko Industrial Park
Tauranga 3110, New Zealand
Instruction Manual English 620305_V01_260811
© Copyright 2011, all rights reserved, Bluelab Corporation Limited
Bluelab Probe Care Kit -
Conductivity contents:
› Cleaning instructions inside box lid
› 500ml 2.77EC conductivity standard solution
› Decanter vessel
› Bluelab Conductivity Probe Cleaner
› Bluelab Chamois (probe cleaning instrument)
Fax: +64 7 578 0847