Remote Control; Installation And Connections - Elta 2402N Manual De Instrucciones

All manuals and user guides at all-guides.com

Remote control

1. PLAY / PAUSE: Play/pause
2. SKIP -: Previous track / search track backward
3. PROGRAM: Program mode
4. STOP: Stop playback
5. SKIP +: Next track / search track forward
6. REPEAT: Repeat modes

Installation and Connections

Insert batteries into the remote control (not supplied)
1. Remove the battery compartment cover by pressing it
down and sliding it out.
2. Insert 2 AAA batteries type "AAA / UM – 4", 1.5V into the
battery compartment. Please observe the correct polarity as
marked with "+" and "-" inside the battery compartment.
3. Replace the cover by pushing onto the battery compartment
until it snaps in.
Battery Safety Precautions
• Follow the battery manufacturer's safety and usage instructions.
• Keep batteries away from children and pets.
• Do not throw batteries into fire. Never expose batteries to heat or fire.
• Disposal of batteries: Dispose exhausted batteries according to the local laws and regulations. For further
information, please contact your disposal authority.
• Do not mix exhausted and new batteries or normal and rechargeable batteries.
• Do not mix different battery types (e.g. alkaline, zinc/carbon, rechargeable batteries). Use only batteries of
the same type and size.
• During longer periods of non-use, please remove the batteries.
• Wrong usage of batteries can cause a leaking of the electrolyte and corrode the battery compartment or let
the batteries burst.
Notes about the remote control:
• If the operation range of the remote control becomes smaller, the batteries are exhausted and must be
replaced.
• Press the keys soft, but firm.
• Direct the remote control unit from no more than about 6 m from the remote control sensor and within an
angle about 60° towards the sensor window on the front of the device.
• Do not direct bright lamps towards the sensor.
• The operation range depends on the brightness of the room.
• Objects between the remote control and sensor window block the transmission.
• Do not use the remote control simultaneously with remote controls of other devices.
Connection of the speakers
Uncoil the speaker wires and connect them to the speaker terminals SPEAKER (L / R) (16).
16.
1
5
2
3 6
4