Assembly Instructions - Kobalt SGY-WS5 Manual De Instrucciones

ASSEMBLY INSTRUCTIONS

1. Using the hex key (FF), first remove the bolt (EE) then
the plug pin (DD) from the foot bar (E).
HARDWARE USED
M6 11.6 x 34mm
DD
Plug Pin
EE M6 x 35mm Bolt
FF
5mm Hex Key
2. Repeat step 1 for the foot bar with leveling knob (F).
NOTE: Do not remove the screw from the stand foot.
There is a secondary plug pin inside the stand foot
that the screw goes through. On the bottom of the
support leg, insert the plug pin (DD) through both holes.
NOTE: Make sure that the threaded hole is facing
toward the bottom of the leg support. Use the hex
key to tighten the screws.
HARDWARE USED
M6 11.6 x 34mm
DD
Plug Pin
EE M6 x 35mm Bolt
FF
5mm Hex Key
3. Position roller (A) so that the two holes on the mounting
plate of the roller are aligned with the hole on the
height indicator (the side with the letters). Insert the
previously removed bolts (AA) through the holes and
then tighten in place using flat washers (CC), the
previously removed nuts (BB), the hex key (FF) and a
wrench (not included) (see Figure 4).
NOTE: Make sure when tightening the roller assembly
that the roller stays level. Screw the locking lever (B)
into the side of the leg support frame.
HARDWARE USED
AA M6 x 35mm Bolt
BB M6 Nut
CC M6 Flat Washer
FF 5mm Hex Key
1
1
1
1
1
1
2
2
2
1
1
2
3
4
5
Back
Front
kobalttools.com