Chapter 3 Installation & First Time Setup; Hardware Installation - Avermedia Capture Box Manual Del Usuario

Tabla de contenido

Publicidad

Chapter 3

3.1 Hardware Installation

Please follow the steps below to properly connect the Capture Box and your TV / video game consoles.
 The Capture Box supports one game console connection at a time only. Connecting more than one console
to the Capture Box at the same time may result in video quality issues, even if only one console is on.
 Before making the connections, make sure to set game console's video output to "Component" and adjust its
output resolution to 1080p or below. Then power your game console off.
 If you would like to install internal hard drive, install it before making the connections.
 Make sure that the cables are firmly connected and that neither of the cables are loose. If any of the cables
are loose or disconnected, there may be a loss of signal or screen color problems.
Step 1
Connecting the Device to Your Game Console Using Universal Component
Cable
Universal Component Cable is used to hook up your game console to the Capture Box at a time.
This cable is composed of component video cable with RCA audio cable at one end and three cables
compatible with PS2/3, Xbox and Wii at the other end.
Step 1-1
:
Plug the green, blue, red connectors into the COMPONENT VIDEO IN port on the rear of the device.
Step 1-2
:
Plug the white and red connectors into the AUDIO IN port on the rear of the device.
Step 1-3
:
Plug the other end to your game console (choose a console-specific cable).
Make sure not to mix up the two red cables.
Installation & First Time Setup
English-7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

C281

Tabla de contenido