EN
START-UP
Open all gate valves in the suction
and discharge lines. Switch on
the power and the pump will start
automatically. While doing so,
leave the discharge tap open to
bleed any air there may be in the
system. Then, close the tap and the
assembly will shut down when it
reaches maximum pump pressure.
Verify the motor sense of rotating
is clockwise, checked from the fun
cover (Fig. 2).
If the assembly does not operate,
does not produce pressure or does
not shut down, try to discover the
cause of the problem consulting
the troubleshooting guide provided
below.
MAINTENANCE
Our unit requires no specific
maintenance. Notwithstanding, we
recommend that they be emptied
when temperatures are low and
there is a risk of freezing or if the
unit is not to be used for a long
period of time. If the unit is not to
be used for a very long period it
should be cleaned and stored in a
dry, well-ventilated place.
8
DECLARATION
OF CONFORMITY
We declare under our exclusive
responsibility, that the product
Pressure booster 800W with code
VIGP800, meets the following
standards or standardization
documents:
EN 60335 -1; EN 60335 -2-41;
EN 62233; EN 55014-1;
EN 55014-2; EN61000-3-2
and EN 61000-3-3, according to
the determinations of the directives:
2014/35/EC - Low Voltage
Directive.
2014/30/EC - Electromagnetic
compatibility directive.
2006/42/EC - Machinery
directive.
2000/14/EC - Sound power level
guaranteed: 86 dB.
S. João de Ver,
07 th of July of 2020
Central Lobão S. A.
Responsible for the Technical File
WARRANTY
TERMS
The warranty of this machine is two
years from the date of purchase.
You should, therefore, keep your
proof of purchase during this period
of time. The warranty covers any
manufacturing defect in material or
operating, as well as parts and work
needed for their recovery.Excluded
from the warranty the misuse of the
product, any repairs carried out by
unauthorized persons (outside the
service center of the brand VITO)
as well as any damage caused by
the use of it.