Troubleshooting - ADEO Services ZSPW400-D Modo De Empleo

Clean and store the pump in a frost-free place before the first frost arrives.
TROUBLE-SHOOTING
Problem
Pump is running . but doesn't
dellver
Pump doesn't start
suddenly stops
operation
Pump runs , but output
suddenly decreases
RECYCYLING
When your pump is broken, do not throw it anywhere: make a simple gesture for
the environment.
Bring your pump to a collection center of electrical appliances so that it can be
effectively retired in the chain of proper waste disposal.
Recycle unwanted materials instead of disposing of them. All appliances and
packaging should be sorted and tendered at a regional recycling centre into to be
processed in an ecological manner.
Probable cause
Air cannot escape , since
pressure line is closed
Air locks in the suction base
Turbine clogged
When starting the pump ,
water height falls below the
min, water level
or Thermal overload switch has
during switched the pump off due to
overheating .
No power
Dirt particles are jammed in
the suction base
Suction base is clogged.
Remedy
Open pressure line (e.g.
kinked pressure pipe)
Wait for max 60 seconds
until the pump deaerates
automatically over the vent
valve. ,if necessary , switch
off and start it again.
Disconnect plug and clean
turbine
Submerge pump deeper
Disconnect plug and clean
turbine
Observe max ,
temperature of 35 ℃
Check fuses and electric
connections
Disconnect plug and clean
suction base
Disconnect plug and clean
suction base
EN
media