General Safety Warnings - EDM 07214 Instrucciones De Uso

INSTRUCCIONES IMPORTANTES DE SEGURIDAD
07214
REF.
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
INSTRUCTION MANUAL
EN

GENERAL SAFETY WARNINGS

READ THESE INSTRUCTIONS CAREFULLY AND KEEP THEM FOR FUTURE CONSULTATION - WARNING: TO REDUCE THE
POSSIBLE RISKS OF FIRE, ELECTRICAL DISCHARGES OR PERSONAL INJURY, TAKE THE FOLLOWING INTO ACCOUNT
GENERAL SAFETY
1. The unit should be hung on the wall and make the wind outlet down or laid on level. You must not place it precipita-
tely or tipsily.
2. Please do not use the heater in the place where full of combustible or explosive gas. Don't cover the wind outlet.
3. If the supply cord is damaged, it must be replaced by the manufacture or its service agent or a similarly qualified
person in order to avoid a hazard
4. The unit must not be located immediately below a fixed electrical-outlet. The electrical-outlet must be equipped with
installment of earth whose capacity should AC250V 10A . The socket and the power plug should be in good connecting
condition.
5. If nobody is in or you are repairing the heater, please put off the plug-in
6. Please don't touch the unit by the wet hand or other conductor when it's working..
7. Motor is out of order, please make it stop immediately.
8. During using the heater, please do not continually open the door or window otherwise it will influence the heating
effect.
9. If want to close the machine, press the on/off switch to off, then the machine keep the fan working about 30 seconds
until it blowing out cool wind, then machine will stop working and you can put off the plug-in.
10. Must hang the heater on the wall and fix it away from water in bathroom.
11. Remote control, please use AAA battery, is matched with the unit.
If the product needs repair, please ask for special person or our company authorized maintenance department.
POSITIONING OF THE APPLIANCE
Get two holes on the wall 1.8meters above the floor and near the corner more 20mm, be sure to make the diameter
just as same as the expanding pipe. Fix two screws on the expanding pipe, keep the tips of the screws out for 10mm,
and hang up the machine after the screws are fixed enough.
OPERATING INSTRUCTIONS
1. Plug into any 220~50 Hz, AC source. Power polity lamp is bright, please use remote control or soft button setting
time and power.
2. During using if you feel room temperature is too high/ low, you can press remote control panel "+" or "-" to adjust
temperature, LED will display "room temperature" or "regulation temperature".
3. Turn the heater on by press the button on control panel, The unit will display the current room temperature, automa-
tic into "fan" mode, and blow the natural wind.
4. Upon turning the heater button again, the unit will set the heater into low heat mode.
5. Pressing the heater button three times, the unit will set the heater into high heat mode.
6. Pressing the heater button once again, switch off the heater. To turn the heater off, Press the heater button again,
cycle operation.
-6-