Electrical Connection - IGNIA LIGHT RGB DMX ONLED Manual De Instalación Y Mantenimiento

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions before
beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the Projector Mini o Halospot RGB-DMX, follow the instructions provided
below:

1. ELECTRICAL CONNECTION

The projectors are supplied with a 2-wire 1.5mm2 Cu H07RNF cable.
This projector has been designed to operate only with a DMX control and with the DMX power supply (code
I0832DMX and I0832DMXFE). It doesn't work with any other control system.
2. CONTROL SYSTEMS OF THE RGB-DMX LED PROJECTORS
Mini, Niq and Halospot Led projectors use 3 DMX channels, one to each one of three primary colours RGB (red, green
and blue). The configuration of DMX direction is realized from the DMX Power Supply code I0832DMX or I0832DMXFE.
The Power supplies achieve to connect until a maximum of 60W for I0832DMX and until 400W for I0832DMXFE. The
Power supply has 6 point outputs, which it is indifferent what of them are connected the projectors.
Internal power supply (P.Máx=60W)
External power supply (P.Máx=400W)
DMX IN/OUT
- +
+ - + - + - + - + - + -
OUTPUT FOR DMX PROJECTORS
DMX LINE
- +
TERMINATION
See manual of the DMX mains lead
code I0832DMX for information
regarding how to assing DMX
addresses to each projector and
See manual of the DMX mains lead
code I0832DMXFE for information
regarding how to assing DMX
addresses to each projector and
24V DC
3
how to configure a system.
how to configure a system.