Publicidad
Q)
HINWEISE ZUR SICHERHEIT
@
Safety advice
lt is important for personal safety that these instructions are followed. Failure to observe these instructions could result in materiał damage or personal injury du ring
the use of this product. The manufacturer bears no responsibility for materiał damage or personal injury caused by failure to observe these instructions.
Take note of the following points before commencing assembly:
The following assembly instructions apply to this product and contain important advice on assembly and operation. They describe the assembly of JAROLIFT
anti-insect blinds for windows. This product is not intended for any use or special application which deviates from these instructions.
I
Correct use
conditions of use
®
The JAROLIFT
™ anti-insect blind is an external anti-insect product, which should only be employed for its intended use. Additional burdens on the JAROLIFT
anti-insect blind for windows, in the form of suspended objects or tethering cords, can lead to the product being damaged or fal ling down and should therefore be
avoided. lntended use of the product also includes ta king note of the following instructions and observing the conditions of assembly. Only use original components
and accessories from the manufacturer.
ATTENTION!
The JAROLIFT
®
'M anti-insect blind is intended to be attached to the window with
positioning aids and assembly elips with double-sided adhesive tape. The doub
le-sided adhesive tape must not be mounted on rough, greasy or dirty surfaces
as this creates a risk of the product fal ling down. Therefore it should not be used
for wooden window frames. Assembly without additional screwing is exclusi
vely intended for PVC and aluminium window frames. When used on wooden
windowframes the assembly aids must also be screwed on. For wooden window
frames, the adhesive fixtures should be thought of as an assembly aid as they
make the assembly and positioning of the blind significantly easier com pa red to
conventional anti-insect blinds.
ATTENTION!
Do not fali out of the window du ring assembly work. Take precautions as the
situation requires. Do not let tools fali out of the window.
ATTENTION!
Attention!!! The spring is al ready pre-adjusted at the factory.
Additional adjustment of the spring is not necessary.
Maximum additional tension = 5 turns. Spring tears if overloaded.
In order to avoid injuries and damages, please take into consideration that the
spring features an extremely high tension setting!
4
...JAFIOLIP:T®™
• Please take note of the product's warning notices and conditions of use.
• Please read all instructions carefully before assembly.
• For your own safety, fol low all safety instructions and settings notes.
There is a danger of injury when cutting the slats. Take the necessary safety
precautions when working with saws.
ATTENTION!
Do not lean against the anti-insect blind while the window is open. The blind
gives way under weight and the re is a danger of fal ling. Therefore do not leave
children or pets unsupervised near opened windows.
ATTENTION!
Check at regular intervals whether the anti-insect blind is stili firmly attached
and that none of the attaching materiał, in particular the double-sided adhesive
tape, has come unstuck.
ATTENTION!
Before the adhesive holder is attached to the window, the window must first be
thoroughly cleaned and any grease removed (for example with cleaning ben
zine or spirit}. Press the adhesive holder on firmly. Additionally, stuck-on compo
nents should be screwed on.
®
'M
®
'M
Publicidad
