Important; Benutzerhandbuch; Allgemeine Warnhinweise - vidaXL 91359 Instrucciones De Uso Y Seguridad

7 Side stay bar
8 Glider handle tubes
9 glider legs
3.2 Slide parts list
19 top ladder rung
20
Chute side stay bar
21 2nd ladder rung
22 3nd ladder rung
23 Bottom ladder rung
24
Ladder leg
25 Ladder handle
26 Ladder handle
27 Lower support tube
6 IMPORTANT: Make sure you read the safety notice on the
front page and always supervise children while they are
playing on the equipment. Once the assembly is completed,
carefully check equipment. In the unlikely event that you do
find any problems, please contact us. Do not allow children
to use this product until the problem has been corrected.
4 Assembly instructions
4.1 Step 1
See image 2
F1 M8 bolt 53mm
S1 M8 U bolt
Frame and Swing Assembly
• Remember to put the swing rope on top of the swing
bearing.
• Should the rope come off during use, please replace back
on top of the swing bearing.
• Ensure bottom leg(11) is connected to the top leg(3) and
not top leg(4)"
4.2 Step 2
See image 3
DE

Benutzerhandbuch

1

Allgemeine Warnhinweise

Lesen Sie alle Anweisungen und Warnungen sorgfältig durch,
bevor Sie dieses Produkt in Betrieb nehmen. Die Nichtbeachtung
von Warnungen und Anweisungen kann zu schweren
Verletzungen, Tod oder Sachschäden führen. Überprüfen Sie
15 Spanner
16 Allen Key
28 Ladder handle
29
Support strap
30 Support strap
31 Support strap
32 Upper slide
33
Lower slide
34 Connector
35 Ground pegs
F2 M6 bolt 47mm
A Rope
G1 M6 bolt 42mm
G2 M8 bolt 39mm
G4 M8 bolt 82mm
G5
M6 bolt 40mm
Glider Assembly
• Assemble seats (12) and attach to seat tubes (10) before
tightening bolts (G4).
4.3 Step 3
See image 4
F3 M6 bolt 35mm F6
F4 M6 bolt 20mm B
F5 M6 bolt 17mm C
1. Slide Chute Assembly
2. Bracket Assembly
The F3 bolts for part 31 must be finger tight ONLY.
3. Assembly of the bracket onto the slide
4.4 Step 4
See image 5
C1 M6 bolt 60mm
C2
M6 bolt 47mm
C3 M6 bolt 40mm
Wavy Chute Assembly Continued
5 Please Note: Top ladder(19) rung is to be fitted behind
ladder handle(26,28) and bottom leg(11)
• Please assemble tube 22 last.
• Leave the bolts loose until the chute is assembled to the
ladder frame,to ease construction, then tighten firmly.
4.5 Step 5
See image 6
P1 M6 bolt 58mm
P2 M6 bolt 47mm
Anchoring the Gym to the ground
5 IMPORTANT: For safety reasons this gym MUST be
anchored and concreted into the ground.
vor der Installation, ob alle Zubehörteile vollständig vorhanden
und unbeschädigt sind. Falls das nicht der Fall sein sollte,
wenden Sie sich bitte an unseren Kundendienst. Bewahren Sie
diese Anleitung zum späteren Nachschlagen an einem sicheren
Ort auf. Verwenden
Originalzubehörteilen. vidaXL haftet nicht für Beschädigungen
G6 M6 bolt 35mm
G7 M6 bolt 38mm
G8 Thin plastic spacer
G9
Thick plastic spacer
M6 bolt 66mm
One connector for both sides
Top of chute
C4 M6 bolt 40mm
C5
M6 bolt 58mm
C6 M6 bolt 62mm
D Concrete
Sie dieses Produkt nur
DE___Benutzerhandbuch |
mit
9