Installation - Indel Webasto Marine Isotherm BI29 Dual Instrucciones Para La Instalación Y El Uso

User Manual

5.1 Installation

Isotherm products have been designed and constructed exclusively for recessed Isotherm products have been designed and constructed exclusively for recessed
installation. installation.
WARNING! The product must be installed horizontally and the compressor WARNING! The product must be installed horizontally and the compressor
must always be installed with its rubber feet resting downward. must always be installed with its rubber feet resting downward.
The compressor is capable of functioning at angles of up to 30°. The compressor is capable of functioning at angles of up to 30°.
WARNING! The compressor can become damaged with any higher WARNING! The compressor can become damaged with any higher
inclinations. inclinations.
Also remote operation compressors must be installed with its rubber feet resting Also remote operation compressors must be installed with its rubber feet resting
downward. downward.
Secure the product so that it cannot tip/slide in the event of rough seas or in the case Secure the product so that it cannot tip/slide in the event of rough seas or in the case
of sudden vehicle movement. The product should be anchored by at least 2 fastening of sudden vehicle movement. The product should be anchored by at least 2 fastening
points, in accordance with the provisions of the EN 60335-2-24 standard. points, in accordance with the provisions of the EN 60335-2-24 standard.
The covers supplied with the product (Fig. 3B) are insulated and provided with The covers supplied with the product (Fig. 3B) are insulated and provided with
special gaskets so as to ensure correct functioning of the product and to maintain the special gaskets so as to ensure correct functioning of the product and to maintain the
correct temperature, but they are not finished on the surface and are not provided correct temperature, but they are not finished on the surface and are not provided
with hinges or handles. with hinges or handles.
Install cladding for covers (not provided by Indel Webasto Marine Srl) as illustrated in Install cladding for covers (not provided by Indel Webasto Marine Srl) as illustrated in
(Fig. 3A), fastening any hinges and/or handles on the cladding. (Fig. 3A), fastening any hinges and/or handles on the cladding.
WARNING! Make sure that the cover has been properly closed, check that WARNING! Make sure that the cover has been properly closed, check that
the gasket is sealed properly on the trunk. the gasket is sealed properly on the trunk.
21