Publicidad
Idiomas disponibles
Idiomas disponibles
MC-5451330-Bedien-0909.qxd
few minutes and attempt to start the
charging process again. Should the
LED not go out even after several
attempts and longer waiting periods,
please contact the specified service
station.
Note: The range of the battery is
influenced by the charged state, the
frequency of use, the material being
processed and the level of energy
required to do so.
A new battery only reaches full
performance capability after 5 charge
and discharge cycles.
It the range of a freshly charged battery
should drop considerably when
compared to a new one, the battery is
old and should soon be replaced by a
new one. To do this, contact the
specified service station.
The rechargeable battery is protected by
a thermo-protection fuse against
overcharging - nevertheless it should be
withdrawn from the charging unit on
expiry of the charging time. A constant
heating of charging unit and rechargeable
battery during the charging is normal and
does not represent any malfunction.
TIP! It is recommended
additionally to control the
charging process via an electrical
time-switch clock!
8 – Torque setting
The drill screwdriver has a 23-stage torque
setting (2) in order to avoid damage to the
bolt or drilling heads. By rotating the head
on your drill screwdriver, you can adjust
the stage necessary in each case, from 1
11.09.2009 16:34 Uhr
(easily turned screw) to max. (stiff screw-
driving/drilling
torque most favourable for the respective
work.
9 – Operation
All standard screwdriver bits, bit holders
and drills, up to a diameter of 10 mm
(not in the scope of delivery), can be
clamped in the drill chuck (1) (Fig. 4).
The machine is provided with a quick-
action drill chuck. In this way, you can
replace the accessories in manual
operation rapidly and without drill chuck
keys (Fig. 5).
is always fixed with a left-hand thread
bolt. This is to be loosened in front
through the drill chuck (1) before a
drill chuck change. Left-hand thread
bolts can be loosened through
clockwise rotation only.
The screwdriver bits and drill bits with a
length of 50 mm can also be inserted
directly into the bit receptacle.
Prior to start up
Insert a wood screw gently into the hole
pre-drilled using a drill bit. Machine
screws should be started off gently. Fit
a suitable bit or socket to the battery-
powered screwdriver and place firmly
against the screw.
Starting and stopping
too deep. Watch the screwing
Seite 63
). Always select the
The drill chuck of clockwise/
anti-clockwise rotation machines
Caution! Risk of over winding
caused by screwing screws in
63
Publicidad
Capítulos
