StarMax FTFFT40-8MBF Manual De Usuario página 3

PART FIGURE
1. Front fuard 2. Blade
3. Plastic nut 4. Rear guard
5. Motor shaft 6. Oscillation knob
7. Fan body 8. Spinner
9. Chassis 10. Speed control buttons
11. Tight 12. Loose
ASSEMBLY OF BASE
1. Detach screw from base of the fan.
2. Match locking tab to base and click into position.
3. Tighten the screw in the base to secure the fan to the base.
GUARD & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and the
plastic nut counter clockwise to remove both of them. Fix the rear guard to the
motor then tighten the plastic nut again. (Fig.1)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into groove
of the blade. Turn the spinner counter clockwise to tighten the blade. (Fig.2)
3. Fix the front guard and the rear guard with circlip and then tighten the fan guard
locking screw and nut. (Fig.3)
Plastic nut
Fig.1
OPERATING INSTRUCTION
Speed control
Speed is controlled by the button switch. (-OFF -L -M -H)
L-low M-medium H-high
Oscillation control
To make the fan oscillate, push down on the oscillation knob located on the top
of the motor housing. To stop the fan down from oscillating in the position
desired, push on the oscillating knob once more.
Tilt control
The airflow can be adjusted upward or downward by tilting the fan head to a
vertical angle as desired.
Spinner
Spinner
Tight
Loose
Blade
Fig.2
1
11
8
Tight
Slot
Retaining
Pin
Fig.3
2
4 5
3
2
6
12
7
10
9