Duracell SS912C-M400-ORBT-1 Guia De Inicio Rapido

• Plug-N-Go
•
•
•
•
•
•
•
the fixture.
• s
•
•
•
not have grounding.
ASSEMB LY AND INSTALLATION INSTRUCTIONS
FIXTURE ASSEMBLY (Fig. 1)
Push spotlight fixture (A) into the ground). Turn knob
counter-clockwise and adjust light to desired angle. Turn
knob clockwise to lock into place. Push assembly into the
ground. Note: DO NOT use a hammer. For ground with hard
soil, soften soil by pouring water into the area, create a pilot
hole with gardening tool. Do not attempt to use your weight
to push the fixture into the ground.
"
'
will
"
MULTIPLE FIXTURES INSTALLATION (Fig. 2)
Step 1
Step 2
Connect female connector from transformer to male connector
of the closest light.
Step 3
a re connected. Note: Fi
'
is available
different directions, a splitter is available (sold separately). When
you come to the end of your string, place the cap that was removed
from the transformer female lead (see TRANSFORMER
INSTALLATION step 3) onto the female lead of the last fixture.
Step 4
Cover wire with ground cover.
male connector
female connecctor
( )
1.5m
Step 1
Select a transformer (sold separately) or Plug-N-Go lighting
set (set includes a transformer and lights).
Step 2
Lo cate a power outlet to plug in transformer. lt is recommended
Plug-N-Go
outlet.
Step 3
Locate the female Plug-N-Go lead with connected 15' wire
coming from transformer. Remove the cap (save for later use)
wire is needed to reach the first fixture, a 10' extension
is available (sold separately).
1-855-826-7488 1-855-826-7488
Plug-N-Go Low Voltage
Spotlight
Model: SS912C-M400-ORBT-1
'
'
a
If your layout requires to branch into 2
female connector
male connector
( )
1.5m
Fig. 2
Fig. 3
separately) onto
Note: