Installation Instructions - PVI ATH1232 Guia De Inicio Rapido

INSTALLATION INSTRUCTIONS

1. Ramp comes preassembled. Position the
1
ramp approximately the ramp's length out
from the step or platform. Stand ramp up on
end with the open ends down and the handle
A
side toward you. Reach down and lift first half
of ramp toward the step or landing area and
set it down on top of support. Make sure hook
is pressed firmly against step.
2. Open top half of left side ramp panel (A).
2
3. Unfold left side ramp panel (A) toward you
3
and once again make sure ramp hooks are
pressed firmly against landing area.
A
BB
1. Place adjustable threshold ramp
(A) in desired location. Locate both
holes at end of the adjustable
threshold ramp (A). Mark the pin
INSTALLATION INSTRUCTIONS
locations using a pencil.
1. Place adjustable threshold ramp (A) in desired
location. Locate both holes at end of the
adjustable threshold ramp (A). Mark the pin
locations using a pencil.
2. Remove the adjustable threshold
ramp (A) and then, using a drill and
3/16 bit, drill a hole approximately
2 inches deep. (Note: If anchoring
2. Remove the adjustable threshold ramp (A) and
into concrete, concrete screws
then, using a drill and 3/16 bit, drill a hole
approximately 2 inches deep. (Note: If
need to be used.)
anchoring into concrete, concrete screws need
to be used.)
3. Replace the adjustable threshold
ramp (A) and screw the flat head
pan screws (BB) into the holes to
3. Replace the adjustable threshold ramp (A) and
screw the flat head pan screws (BB) into the
secure it in place.
holes to secure it in place.
Hardware Used
Flat Head
BB
Pan Screw
5
5
1
2
3
A
B
A
B
A
B
x 2
5