LEDLux LL0256 Manual De Usuario página 7

NO Options
A1 Temperature Calibration
Start/Stop
A2
temperature difference
A3
Child lock
A4
Integrated sensor
A5
High temperature protection
Low temperature protection
A6
A7
Frost protection
A8
Maximum Limit
A9 Programmable Week
Advanced Options Mode 2 (Through PRG)
With power off status, long press
to access advanced settings, to switch between
one setting to another then use the key
Short press
After finishing the setting,
wait about 5 seconds to exit
Valve Control
B1
An freeze func on
B2
(descaling func on)
GA / GB op on
B3
°C o °F
B4
Restore data
B5
from Factory
35-70°C
5-10°C
-
+
or to change options
0 represents the valve is controlled by the thermostat
1 the valve is not controlled by the thermostat, it is always closed
0 closed, 1 open. When the valve is continuously closed
for over 100 hours, it will be open for 3 minutes。
0-GA ： valve switch protection is about 3 sec.
1GB ： valve switch protection is about 5 sec.
Degree Celsius or degree Fahrenheit
Once you have reached B5, press the key
button
Functions
-9 / +9°C
~
1 5°C
0: Partial
1: Total
Single Sensor
if the internal temperature is
higher than that set
heating will be stopped
if the internal temperature is
lower than that set
heating will be stopped
1-10°C
30-70°C
P1: 5+2 P2: 6+1 P3: 7
+
and keep it pressed for a few seconds
Default
SET
SET several times
-1°C
1°C
0
N1
45°
5°C
5°C
35°C
P1