Denver CRI-820 Manual De Instrucciones página 4

WAKE UP TO BUZZER
1. With the unit powered off, press the AL1 or AL2 button until the following icon appears on
the LCD display.
2. At the alarm time set, the alarm will activate by buzzer.
3. To stop the alarm temporary, press the snooze button.
4. The alarm will activate again after 9 minutes.
5. To turn off the alarm, press the POWER ON/OFF button.
WAKE UP TO iPOD
1. With the unit powered off, press the AL1 or AL2 button until the following icon appears on
the LCD display.
2. Connect the iPod to the docking connector and turn off the iPod
3. At the alarm time set, the alarm will activate by iPod.
4. To stop the alarm temporary, press the snooze button.
5. The alarm will activate again after 9 minutes.
6. To turn off the alarm, press the POWER ON/OFF button.
LISTENING TO THE AM/FM RADIO
1. Press the POWER ON/OFF button to turn on the unit.
2. Press the BAND button to select AM or FM band.
3. Press the TUN+ or TUN- buttons step by step to tune to the desired radio stations.
4. Press and hold the TUN+ or TUN- button for approx. 1 second, it will start to search the next
radio station in the direction of the search. The search operation simply finds stations with
strong signals. Stations with weak reception can only be tuned in manually.
SAVING A RADIO STATION TO THE MEMORY
1. Tune the radio to the desired station.
2. Press the MEM/TIME button, then MEM+ or MEM- button to select a memory slot for the
current station. Press the MEM/TIME button after the desired memory slot is chosen.
3. Press the MEM+ or MEM- buttons to cycle through the saved radio stations on the unit.
4. Up to 20 radio stations can be stored in the memory.
LISTENING TO iPOD WITH DOCKING CONNECTOR
Warning : Turn off your iPod before docking on the unit
1. Press the FUNCTION button to select iPOD mode.
2. Connect the iPod to the docking connector.
3. You can use the PLAY/PAUSE button, MENU button, SELECT button, SKIP+ button, SKIP-
button, SCROLL+ and SCROLL- button on the unit to operate your iPod.
4. Your iPod recharges (until fully charged) while it is docked in the unit and the unit is
connected to AC or battery power.
Warning : Please make sure you are using the correct adaptor for your iPod and that it is properly
docked into the unit. Failure to do so may damage your iPod.
All manuals and user guides at all-guides.com
- EN 5 -
AUX-IN CONNECTION
1. Insert one side of the audio cable into the Line-Out or Phone jack on your MP3 Player or
audio device and the other side into the AUX-IN jack.
2. Use the FUNCTION button to select the AUX mode.
3. Turn on your MP3 player or audio device and follow the component's instructions.
Specifications
Dimension : 232 (W) x 105 (H) x 116 (D) mm
Frequency Range: AM 520 - 1650 KHz
FM 88 - 108 MHz
Power Supply: Input : AC 230V ~ 50 Hz
Output : DC12V 700mA
Specifications are subject to change without prior notice.
Instructions on environment protection
Do not dispose of this product in the usual household garbage at the end of
its lifecycle; hand it over at a collection point for the recycling of electrical and
electronic appliances. The symbol on the product, the instructions for use or
the packing will inform about the methods for disposal.
The materials are recyclable as mentioned in this marking. By recycling,
material recycling or other forms of re-utilization of old appliances, you are
making an important contribution to protect our environment.
Please inquire at the community administration for the authorized disposal
location.
ALL RIGHTS RESERVED
DENVER ELECTRONICS A/S
www.denver-electronics.com
- EN 6 -