Matco Tools HSGKR Manual De Instrucciones página 3

PLASTIC WELDING TIP WITH FILLER ROD FEEDING TUBE
• Use in a similar method to the standard plastic welding tip; the supplied filler rods are fed through the tube
so that they melt directly onto the job. Used for deeper cracks that have been V-ed out to take the filler.
• Used to add filler rod material to reinforce the repair and bring the repair to surface level.
• Run the tip along the crack as you also feed the filler rod down through the tip.
Move slowly and carefully making sure the material is of a sufficient
temperature to weld successfully to the substrate.
HOW TO REPLACE THE TIP
1. Ensure tool switch is in the OFF position. Allow tip to cool completely before replacing tip.
2. Use only genuine Matco replacement tips.
3. Unscrew old tip by rotating translucent locking nut counter-clockwise about 1/4 turn.
4. Screw in new tip by rotating translucent locking nut clockwise until it snaps on lock position.
Note: Align the notch on the housing to install the new tip.
5. Do not file the tip, it is plated and will ruin the protective plating.
ADJUST THE DIRECTION OF THE TIP
Rotate the black knurled nut to adjust the direction of the tip.
Knurled Nut
Locking Nut
LED Light
WARNINGS
Potential electrical shock. Do not use tool if housing is cracked or damaged.
Never use in wet area. Do not attempt to repair or modify tool. Always de-energize devices being soldered.
Potential burn hazard. Hot tip can cause severe burns. Do not touch tip of tool. Allow tool to cool before
touching tip or replacing protective cap.
Tip remains hot after use for several minutes.
• Work only in a dry area.
• Work only in areas free from flammable materials.
• Always store the tool in a dry place out of reach of children or anyone who has not read these instructions.
• Always were eye protection and gloves when operating the tool.
• Never touch the tip of a hot tool or attempt to remove plastic from the tip with your hands.
• Always rest the tool where heat from tool cannot damage nearby items.
• Ensure that switch is in the OFF position when the iron is not in use.
• Ensure tip is cool before storing the tool. Never leave tool unattended.
• Do not disassemble or modify the battery. The battery contains safety and protection devices
which if damaged, may cause the battery to generate heat, rupture or ignite.
CORDLESS HOT STAPLE GUN
Page 3
HSGKR
2003043-14