Primo Water 900139 Manual De Usuario página 10

8. Remove plastic baffle from inside reservoir.
9. Clean probe assembly and baffle with a soft cloth using a mixture of one gallon tap
water and 1 tablespoons unscented household bleach, then rinse.
10. Wipe inside of reservoir and area around both taps with a soft cloth using a mixture
of one gallon tap water and 1 tablespoons unscented household bleach. If there is
mineral build-up (white chalky deposits) use a household product designed to
remove calcium, lime or rust. These can be found in grocery and hardware stores.
Follow manufacturer's label instructions.
11. Rinse system by pouring 1-2 gallons of tap water through the dispenser and into the
bucket.
12. Remove remaining water from reservoirs by dispensing from both taps into a pitcher.
13. Replace all parts including silicon plug, drain cap, baffle and probe assembly.
14. Turn unit around and re-clip Wall Mount Strap to back of dispenser.
15. Install a fresh bottle of water after cleaning bottle cap and neck area.
16. Plug power cord into grounded wall outlet.
17. Turn energy saving switch ON.
Model # 900139: Page 10