Habitat Okko 953115 Manual De Instrucciones

Okko
Alarm clock
Réveil
Despertador
Wecker
953115
EN
Indoor use only.
Information to be kept.
Read carefully the instruction sheet before first use.
Characteristics
Sold with a safety class II transformer IP20.
Primary : 220-240V~, 50/60Hz
Secondary : 6V~, 300mA
General instructions
Transformers and power supplies are not intended to be used
as toys, and use of these products by children must be under the
strict supervision of parents.
To prevent unnecessary drain on the battery, install only after
connecting the alarm clock to AC power.
Replace the batteries when the movement is slowed, the sound
or display is distorted / light intensity reduced.
The batteries should be inserted by the polarity and the terminals
should not be short-circuited.
Do not recharge non-rechargeable batteries.
Do not mix batteries and accumulators new and used.
Do not mix alkaline batteries with saline batteries.
Only use the recommended type of batteries.
Remove used batteries or accumulators from the product.
Remove the batteries while not using the unit for long periods.
Clock
1. Alarm on indicator
2. Snooze button
3. Hour set button
4. Minute set button
5. Time set button
6. Alarm set button
7. Alarm ON/OFF button
8. Battery compartment
Okko - 05/2016
To operate clock
Blinking display/Alarm on indicator
When the clock plugged in, the display will blink on and off
meaning the incorrect time is being displayed. In this case, it's
very important to always check the time displayed. When the
alarm indicator is displayed, the alarm will sound at the time set.
Set the time
Press and hold the time set button and the hour set button until
the correct hour is displayed then release the hour set button and
press the minute set button until the correct minute is displayed.
Set the alarm
Press and hold on the alarm set button and the hour set button
or minute set button as above.
To operate the alarm
Slide the alarm ON/OFF switch to the ON position. the alarm will
sound at the time set. to shut off the alarm slide the alarm
ON/OFF switch to the OFF position.
Snooze the alarm
Press the top of the case to activate snooze for 9 minutes.
Battery back up
Insert one 9V battery into the battery compartment located to the
bottom of the clock. The battery will hold the alarm and time
settings until power is restored. If there is no battery and the
power is interrupted, the display will flash and the alarm and time
will need to be reset.
Maintenance
Use a soft cloth or paper towel to clean the clock. Do not use any
corrosive cleaning solution to clean the clock. Keep the clock
clean and dry to avoid any problems.
If you have any comments or suggestions regarding this product,
assembly instructions or service received, please enquire at your
nearest store or contact us on our website at: www.habitat.eu or
write to this address: HABITAT FRANCE SERVICE CLIENT-42/44
RUE DU FAUBOURG ST ANTOINE 75012 PARIS-FRANCE
1