Publicidad
Modular component notice
This product contains the following modular component(s):
LEX‐M06‐001, FCCID:IYLLEXM06001, IC:2376A‐LEXM06001
Exposure to radio frequency radiation
The radiated output power of this device is far below the radio frequency exposure limits of the FCC and
other regulatory agencies. A minimum separation of 20 cm (8 inches) must be maintained between the
antenna and any persons for this device to satisfy the RF exposure requirements of the FCC and other
regulatory agencies.
Industry Canada (Canada)
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a
type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce
potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that necessary for successful
communication.
This device complies with Industry Canada license-exempt RSS standards. Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
To prevent radio interference to the licensed service, this device is intended to be operated indoors
and away from windows to provide maximum shielding.
Industrie Canada (Canada)
Selon la règlementation d'Industrie Canada, l'émetteur radio ne fonctionner qu'avec une antenne
dont le type et le gain maximal (ou inférieur) ont été approuvés par Industrie Canada. Pour réduire
les interférences radio potentielles auprès d'autres utilisateurs, le type d'antenne et son gain doivent
être choisis de telle sorte que la puissance isotrope rayonnée équivalente (PIRE) ne soit pas
supérieure à ce qui est nécessaire pour assurer la réussite de la communication.
Cet appareil est conforme aux normes RSS exemptes de licence d'Industrie Canada. Son
fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer
d'interférences et (2) il doit acceptertoutes les interférences, y compris les interférences pouvant
entraîner un fonctionnement indésirable.
Pour éviter toute interférence radio au service sous licence, cet appareil est destiné à être utilisé à l'intérieur
et à l'écart des fenêtres afin d'assurer une protection maximale.
European Community (EC) directives conformity
This product is in conformity with the protection requirements of EC Council directives
2004/108/EC,2006/95/EC, 2009/125/EC, and 2011/65/EU on the approximation and harmonization
of the laws of the MemberStates relating to electromagnetic compatibility, safety of electrical
equipment designed for use within certain voltage limits, the ecodesign of energy-related products,
and on the restrictions of use of certain hazardous substances in electrical and electronic equipment.
The manufacturer of this product is: Lexmark International, Inc., 740 West New Circle Road,
Lexington, KY, 40550 USA. The authorized representative is: Lexmark International Technology
Hungária Kft., 8 Lechner Ödön fasor, Millennium Tower III, 1095 Budapest HUNGARY. A declaration
of conformity to the requirements of the Directives is available upon request from the Authorized
Representative or may be obtained at www.lexmark.com/en_us/about/regulatory-
compliance/european-union-declaration-of-conformity.html.
Publicidad
