Troubleshooting Guide; Supplied Accessories - Sylvania SRT4127P El Manual Del Propietario

OPERATIONS (Continued)
V-CHIP SET UP
V-CHIP enables parents to prevent their children
from watching inappropriate material on TV.
V-CHIP reads the ratings for programming
(except for news and sports programs, unedited
movies on premium cable channels, and
Emergency Broadcast System signals), then
denies access to programming if the program's
rating meets or exceeds the limitations you
select. In this case, "PROTECTED PROGRAM
by ..." message appears on the TV screen.
To block certain ratings, follow the steps below.
Programming may be rated by the Motion
Picture Association of America (MPAA) or
according to the Television Parental
Guidelines. In order to block any inappropri-
ate programming, set your limits in both
places (MPAA RATING and TV RATING).
You cannot access the menu when the "PRO-
TECTED PROGRAM by ..." message
appears. In this case, change to an unblocked
channel, then press the MENU button.
[MPAA RATING SET UP]
1) Press the MENU button so that the menu dis-
play appears on the TV
screen.
PICTURE
2) Press the CH(annel)
CHANNEL SET
or button to point to
[ENGLISH] ESPAÑOL
B V-CHIP SET UP
"V-CHIP SET UP".
CAPTION [OFF]
Then, press the
TV SOUND [MAIN]
VOL(ume) button.
3) Use the number buttons
ACCESS CODE
to enter 4-digit access
_ _ _ _
code. The default access
code is 0000. If you
have not set up your
personal access code,
you should use 0000.
4) Press the CH(annel)
TV RATING
or button to point to
B MPAA RATING
CHANGE CODE
"MPAA RATING".
Then, press the
VOL(ume) button.
5) Press the CH(annel)
B G [VIEW]
or button to point to
PG [VIEW]
your desired item.
PG-13 [VIEW]
R [VIEW]
Then, press the
NC-17 [VIEW]
VOL(ume) button to
X [VIEW]
select [BLOCK] or
[VIEW].

TROUBLESHOOTING GUIDE

Sometimes a performance problem can be easily solved by checking seemingly apparent but often over-
looked possibilities. Before arranging for service, check these items. It could save you time and money.
QUICK SERVICE CHECK LIST
POSSIBLE REMEDY
Try a new channel, if OK, then possible station trouble.
Is TV plugged in?
Power at outlet?
Is TV's POWER button on?
Is antenna connected to terminal on the back of the set?
If outside antenna is being used, check for broken wire.
Check for local interference.
Turn off with POWER button and then turn it on after about a minute.
Adjust COLOR control.
Adjust CONTRAST & BRIGHT control.
Check batteries in Remote Control.
Move the TV away from the nearby appliances or unshielded speaker systems
which create a magnetic field.
Turn off using the POWER button, then turn it on again 30 minutes or so later.
Closed Caption Problem
My TV is showing captions that are You are watching a live broadcast and spelling errors made by the
misspelled. closed captioning production company may pass through uncorrect-
ed. A prerecorded program will not show any misspelled words
because of the normal time available for editing the captions.
My TV will not show the text in its entirety Captions that are delayed a few seconds behind the actual dialogue
or there is a delay of what is being said. are common for live broadcasts. Most captioning production compa-
nies can display a dialogue to a maximum of 220 words per minute.
If a dialogue exceeds that rate, selective editing is used to insure that
the captions remain up-to-date with the current TV screen dialogue.
My captions are scrambled with white Interference caused by building, power lines, thunderstorms, etc.
boxes on the TV screen. may cause scrambled or incomplete captions to appear.
My program guide listed a TV show as Broadcasters may at times use a time compression process to the
being closed captioned actual program so that additional advertising time can be given.
but none of the captions were displayed. Since the decoder cannot read the compressed information, captions
will be lost.
My prerecorded videotape does not show The videotape was either an illegal copying or the tape duplicating
any captions. The tape box mentions it company accidentally left out the captioning signals during the
being closed captioned. copying process.
My TV screen shows a black box on certain You are in the TEXT mode. Select CAPTION mode or CAPTION
channels. [OFF].
®
As an E S Partner, our company has determined that this product meets
NERGY TAR
the E S ® guidelines for energy efficiency. E
NERGY TAR
All manuals and user guides at all-guides.com
<Selection> <Rating Category Explanations>
• G: General Audience
• PG: Parental Guidance suggested.
• PG-13: Unsuitable for children under 13
• R: Restricted; under 17 requires
accompanying
parent or adult guardian
• NC-17: No one under 17 admitted
• X: Mature audience only
When you select the rating category and turn it
to [BLOCK], the higher rating will turn
[BLOCK] automatically. Also, the lower rating
will turn [VIEW] automatically.
When you turn "G" to [BLOCK] or [VIEW],
the all ratings will turn to [BLOCK] or
[VIEW] automatically.
When you turn "X" to [VIEW], then all rat-
ings will turn to [VIEW] automatically.
6) Press the MENU button to exit the menu.
[TV RATING SET UP]
1) Press the MENU button so that the menu dis-
play appears on the TV screen.
2) Press the CH(annel) or button to point to
"V-CHIP SET UP".
Then, press the VOL(ume) button.
3) Use the number buttons
to enter 4-digit access ACCESS CODE
code. The default access _ _ _ _
code is 0000. If you have
not set up your personal
access code, you should
use 0000.
4) Press the CH(annel) or
B TV RATING
button to point to "TV
MPAA RATING
RATING". Then, press
CHANGE CODE
the VOL(ume) button.
5) Press the CH(annel) or
button to point to your
desired item.
B TV-Y
TV-Y7( ) [VIEW]
Then, press the
TV-G
VOL(ume) button to
TV-PG( ) [VIEW]
TV-14( ) [VIEW]
select [BLOCK] or
TV-MA( ) [VIEW]
[VIEW].
Possible Remedy
S ® is a U.S. registered mark.
NERGY TAR
<Selection> <Rating Category Explanations>
• TV-Y: Appropriate for all children
• TV-Y7: Appropriate for children seven and
older
• TV-G: General Audience
• TV-PG: Parental Guidance suggested.
• TV-14: Unsuitable for children under 14
• TV-MA: Mature audience only
When you select the rating category and turn it
to [BLOCK], the higher rating will turn
[BLOCK] automatically. Also, the lower rating
will turn [VIEW] automatically.
When you turn "TV-Y" to [BLOCK] or
[VIEW], then all ratings will turn to [BLOCK]
or [VIEW] automatically.
When you turn "TV-MA" to [VIEW], then all
ratings will turn to [VIEW] automatically.
6) Press the MENU button to exit the menu.
[V-CHIP SET UP SUB RATINGS]
When you select TV-Y7, TV-PG, TV-14, or TV-
MA and you press the VOL(ume)
sub-ratings will appear on the TV screen.
If you select the rating category (example: TV-
PG) and turn it to [BLOCK] or [VIEW], the
sub-ratings (example: V for Violence) will turn
[BLOCK] or [VIEW] automatically.
You can set the sub-ratings to [BLOCK] or
[VIEW] individually when the rating category
is set to [BLOCK]. To set the sub-ratings indi-
vidually, follow the steps below.
When you select [TV-Y7]:
Press the CH(annel) or
button to select "FV"
(Fantasy Violence). Then,
press the VOL(ume) B FV
button to select [BLOCK]
or [VIEW].
[VIEW] When you select [TV-PG], [TV-14] or [TV-
MA]:
[VIEW]
Press the CH(annel) or
TV-PG
button to select "D"
(Suggestive Dialog),
D
"L"(Coarse Language), L
S
"S"(Sexual Situation), or
V
"V" (Violence). Then,
press the VOL(ume) button to select
[BLOCK] or [VIEW].
Note: When you select [TV-MA], "D" does not
appear on the TV screen.
MAINTENANCE
CABINET CLEANING
Wipe the front panel and other exterior sur-
faces of the TV with a soft cloth immersed
in lukewarm water and wrung dry.
Never use a solvent or alcohol. Do not spray
insecticide liquid near the TV. Such chemi-
cals may cause damage and discoloration to
the exposed surfaces.

SUPPLIED ACCESSORIES

Remote control unit
(N0147UD)
Batteries ("AA" x 2)
SPECIFICATIONS
GENERAL SPECIFICATIONS
Television system: NTSC-M
TV Standard
Closed Caption
System: §15.119/FCC
Channel coverage
VHF: 2 ~ 13
UHF: 14 ~ 69
CATV: 2 ~ 13, A ~ W,
W+1 ~ W+84,
A-5 ~ A-1, 5A
Tuning System 181 channel
frequency synthesized
tuning system
Channel access: Direct access keyboard,
programmable
scan and up/down
Terminals
Antenna input: VHF/UHF/CATV
75 ohm unbalanced
(F-type)
S-Video input: Mini DIN 4-pin jack
Video input: RCA connector x 2
Audio input: RCA connector x 6
Audio output: RCA connector x 2
Component Video Input
One pin jack (Y) / 1Vpp (75 ohm)
(480i only, not progressive scan)
Two pin jack (P /P ) / 700m Vpp (75 ohm)
B R
Stereo Sound System
2 speakers
The sub-ratings which set
to [BLOCK] appear next
to the rating category in
the TV RATING menu.
[V-CHIP ACCESS CODE]
To change access code, follow steps.
1) Press the MENU button,
then press the CH(annel)
or button to select
V-CHIP SET UP. Press
the VOL(ume) button
to continue.
2) Press the number buttons
to enter your old access
code. If you have never
set up your personal
access code, use 0000.
3) Press the CH(annel)
button to select
CHANGE CODE. Then,
button, the
press the VOL(ume)
button to continue.
4) Use the number buttons
to enter your desired
access code in the NEW
CODE space. Then, enter
the same code in the
CONFIRM CODE space.
Your new access code is
set. You will return to the
"V-CHIP SET UP".
If the code in the CONFIRM CODE space does
not match the code in the NEW CODE space,
TV-Y7 [BLOCK]
repeat step 4, making sure you enter the same
[BLOCK]
new code exactly in the CONFIRM CODE space.
Notes:
• If a power failure occurs, the default code,
0000, will be the active access code again.
• If you connect the power cord to an AC outlet
that is controlled by a wall switch, your person-
[BLOCK]
al access code will be erased every time you
turn off the power at the wall switch. The
[BLOCK]
[BLOCK]
default code will be the active code again.
[BLOCK]
[IF YOU FORGET YOUR ACCESS CODE]
[BLOCK]
To restore 0000 as your personal access code,
unplug the TV's power cord for 10 seconds, then
plug it in again.
PICTURE TUBE CLEANING
Wipe the picture tube of the TV with a soft
cloth. Before cleaning the picture tube, discon-
nect the power cord.
Owner's Manual
(0EMN02285)
ELECTRICAL SPECIFICATIONS
Sound output:
OTHER SPECIFICATIONS
Remote control:
Operating
temperature:
Power requirements: AC120V, 60Hz
Power consumption
(Maximum):
Picture tube:
Dimensions:
Weight:
•Designs and specifications are subject to
change without notice and without our
legal obligation.
•If there is a discrepancy between languages,
the default language will be English.
B TV-Y [VIEW]
TV-Y7( ) [VIEW]
TV-G [BLOCK]
TV-PG(DLSV) [BLOCK]
TV-14 (DLSV) [BLOCK]
TV-MA( LSV) [BLOCK]
PICTURE
CHANNEL SET
[ENGLISH] ESPAÑOL
B V-CHIP SET UP
CAPTION [OFF]
TV SOUND [MAIN]
ACCESS CODE
_ _ _ _
or
TV RATING
MPAA RATING
B CHANGE CODE
NEW CODE
_ _ _ _
CONFIRM CODE
_ _ _ _
Owner's
Manual
3W, 8 ohm x2
Digital encoded
infrared light system
5°C to 40°C
(41°F~104°F)
134W
27"
H : 23-1/16" (585mm)
W: 29-5/16" (745mm)
D : 19-7/8" (505mm)
94.8 lbs. (43kg)