Installation - Glacier bay 67735-0001 Guía De Instalación Y Cuidado

Ocultar thumbs Ver también para 67735-0001:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation

1
Installing the connector
CAUTION: Always shut off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
Shut off the water supply. Remove the old
faucet.
Clean the mounting surface.
Wrap thread sealant tape (not included) around
the stub out pipe threads (1) extending from the
wall in a counterclockwise direction, as shown.
Place the ange (C) onto the connector (D) and
wrench-tighten the connector (D) onto the stub
out pipes (1) extending from the wall (do not
over tighten).
C
D
3
Installing the faucet assembly
Insert the washers (E) into the faucet body (A),
and then wrench-tighten the faucet body (A)
to the connectors (D).
2
1
A
4
Installing the spout assembly
Thread the spout assembly (B) onto the faucet
body (A) and hand tighten the spout assembly (B)
to ensure a complete seal.
D
E
B
A

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Hd67735-0008d2732503771300

Tabla de contenido