Installation With The Vehicle's 2-Point Seat Belt - Mercedes-Benz BABY-SAFE plus II Instrucciones De Servicio

15
®
10. Fold out D-SIP
X
vehicle door.
Note: The extended D-SIP
additional accident protection in the event
of a side impact. Never use it to carry or
secure the child seat.
Checklist for correct installation
For the safety of your child, check before
each journey that:
the child seat is installed against the
^
direction of travel.
the child seat is only attached to the front
^
passenger seat if no front passenger
airbag can act on the child seat.
the child seat is secured in the vehicle with
^
the LATCH as described above.
LATCH j is routed through the two blue
^
belt guides c of the child seat.
both LATCH arms g and k are engaged
^
in ISOFIX securing rings h of the vehicle.
®
D-SIP f on the side of the vehicle door
^
is folded out.
the LATCH is tightened and not twisted.
^
f on the side of the
®
serves as
Installation in the vehicle
Installation with the vehicle's 2-point
seat belt
DANGER!
G
The seat belt must be pulled tight and must
not be twisted. If the seat belt of the child
seat is incorrectly secured or is not
secured at all, in the event of an accident,
abrupt braking maneuver or a sudden
change in direction, the child may
otherwise not be restrained and may be
seriously or fatally injured.
1. Securing the child in the child seat; see
X
page 10.
2. Place the child seat on a suitable vehicle
X
seat against the direction of travel and
secure it against tipping over.
Note: The inclination of the child seat is
correct if there is a space of about two
fingers at the front between the child seat
and the seat surface of the vehicle seat.
(Arrow)
3. Lock carrying handle 5 in the upper
X
position A.
15