Uline H-7733 Manual Del Usuario página 2

CHARGING THE FLASHLIGHT
This flashlight is equipped with a
magnetic USB charger. Position the
charger end cap over the On/Off
push switch (See Figure 1) and
you will feel a strong magnetic
force pull the two firmly together.
Plug the USB end of the charger
cable into a computer's USB slot
or into the supplied adapter that
can be used in a standard 110V
AC power outlet. While the unit
is charging, an indicator on the
charger end cap will glow red.
When this turns green, it means
that the unit is ready for use
and can be removed from the
charger.
NOTE: In order to maximize battery life, the
flashlight should be charged for eight hours on
the first three occasions, regardless of what the
charging indicator shows.
IMPORTANT! Read the following points
regarding the performance/maintenance of
flashlight.
• Charge will drain from battery over time, even if not
used. This is normal.
• Using flashlight in high or low temperatures will
quicken the battery discharge and reduce burn
time.
• Recharge the flashlight as soon as the light begins
to dim, as excessive discharge can shorten
rechargeable battery life.
• Only use the supplied power adapter to avoid risk of
damaging flashlight or battery.
MULTI-MODE SWITCH OPERATION
This flashlight is equipped with four different modes of
operation (See Technical Information on page 1):
High Beam (100%): For indoor, outdoor or long distance
illumination.
Low Beam (10%): For close illumination, such as reading,
repairing or identification.
PAGE 2 OF 9
OPERATING INSTRUCTIONS
Figure 1
Strobe Light (12Hz): For signalling in a rescue situation or
self-defense.
SOS Signal: For use in rescue situations. This mode will
continuously flash the international Morse code signal
for SOS.
User can access the different modes in two ways:
1. Touch: Lightly touch the end cap switch with thumb
to go to first mode. Release the switch and then
touch it again within one second to go to the next
mode. Repeat this to cycle through all flashlight
modes. When all have been shown, it will loop
back to the beginning. Leaving the switch for more
than one second after releasing thumb will result in
cycle being reset to the beginning. Fully depress the
switch to keep the current mode selected.
2. Press: Same procedure as above, but instead of
using a light touch on the end cap switch, fully
depress the switch each time. This will keep current
mode selected unless the procedure is repeated
within one second, in which case the next mode is
selected.
SLIDING OPTICAL FOCUS
This flashlight is equipped with a sliding optical focus
system (See Figure 2) that allows you to choose between
a long beam that is ideal for seeing into the distance or
a wide beam which illuminates more of the surrounding
area. To adjust this, hold the flashlight normally with the
aluminum casing. Then, using thumb and forefinger,
push the head collar of the flashlight to produce a long
beam or pull it back to produce a wide beam.
Figure 2
Long Beam
Wide Beam
0521 IH-7733