Important Safety Instructions; Installation Instructions - Conairphone SW207 Manual Del Propietário

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions
should always be followed to reduce the risk of fire, electric shock
and injury to persons, including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the
product.
3. Unplug this product from the wall outlet before cleaning.
Do not use liquid cleaners or aerosol cleaners. Use a
damp cloth for cleaning.
4. Do not use this product near water, for example, near a
bath tub, wash bowl, kitchen sink, or laundry tub, in a
wet basement, or near a swimming pool.
5. Do not place this product on an unstable cart, stand, or
table. The product may fall, causing serious damage to
the product.
6. Slots and openings in the cabinet and the back or bottom
are provided for ventilation, to protect it from overheating.
These openings must not be blocked or covered. The
openings should never be blocked by placing the product
on a bed, sofa, rug, or other similar surface. This product
should never be placed near or over a radiator or heat
register. This product should not be placed in a built-in
installation unless proper ventilation is provided.
7. Never push objects of any kind into this product through
cabinet slots as they may touch dangerous voltage
points or short out parts that could result in the risk of
fire or electric shock. Never spill liquid of any kind on
the product.
8. To reduce the risk of electric shock, do not disassemble
this product, but take it to a qualified serviceman when
some service or repair work is required. Opening or
removing covers may expose you to dangerous voltages
or other risks. Incorrect reassembly can cause electric
shock when the appliance is subsequently used.
1
9. Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the
following conditions:
a. When the power supply cord or plug is damaged or
frayed.
b. If liquid has been spilled into the product.
c. If the product has been exposed to rain or water.
d. If the product does not operate normally by following
the operating instructions. Adjust only those controls
that are covered by the operating instructions
because improper adjustment of other controls may
result in damage and will often require extensive work
by a qualified technician to restore the product to
normal operation.
e. If the product has been dropped or the cabinet has
been damaged.
f. If the product exhibits a distinct change in
performance.
10. Avoid using a telephone (other than a cordless type)
during an electrical storm. There may be a remote risk
of electric shock from lightning.
11. Do not use the telephone to report a gas leak in the
vicinity of the leak.
SAVE THESE INSTRUCTIONS

INSTALLATION INSTRUCTIONS

1. Never install telephone wiring during a lightning storm.
2. Never install telephone jacks in wet locations unless
the jack is specifically designed for wet locations.
3. Never touch uninsulated telephone wires or terminals
unless the telephone line has been disconnected at the
network interface.
4. Use caution when installing or modifying telephone lines.
2
GET TO KNOW YOUR CONAIRPHONE
1
2
3
4
5
6
7
1. Receiver
2. Ringer On/Off Switch
3. Receiver Volume Control
4. Universal Compatible Keypad (tone or push button rotary)
5. Dial Tone Reset Key
6. Mute Key
7. Transmitter
8. Hook Switch
9. Wall Mount Hook
10. Tone / Pulse Switch
11. Telephone Number Insert
12. Last Number Redial Key (on tone or pulse)
13. Coil Cord
3
TM
8
9
10
11
12
13