General Information - A.E.B. OBD II-μFIX Manual De Instrucciones

General Information

- Install in vertical position away from possible water
infiltration.
- Install away from excessive heat sources
(i.e. exhaust manifolds).
- Install away from ignition coil. Route the wiring Hanes
away from spark plug wires.
- Make good electrical connections, avoiding the use
of wire splicers. Solder and properly isolate all
connections.
- Do not open the simulator box, especially while the
engine is rotating or while the ignition key is on the ON
position. A.E.B. is not responsible for damages to
persons or property resulting from tampering of
its devices by unauthorised personnel.
WARNING!
To perform a diagnosis of the OEM petrol
injection system, it is necessary for the
vehicle to be operating on PETROL.
English
7
IS424 Rev 030401 - 0