HAMPTON BAY Wellston Manual Del Usuario página 11

Attaching the Light Kit
REMEMBER to disconnect the power.
1. Remove the three mounting screws on the
black bracket below the motor.
2. Connect the wires exiting the bottom of
motor with the light kit by connecting the
molded adaptor plugs together.
3. Slide the switch sup light kit and secure it to
the black bracket using the three screws that
were removed in step 1.
4. Insert the shade into the glass holder of
the light kit and turn the compressing ring
clockwise to tighten the glass shade. Repeat
for the remaining shades.
5. With the power off, insert the light bulbs
(included) into the light kit sockets. Max 14
Watts.
Blade Balancing
All blades are grouped by weight. Because nat-
ural woods vary in density, the fan may wobble
even though the blades are weight matched. The
following procedure should correct most fan
wobble. Check after each step.
1. Check that all blade and blade bracket
screws are secure.
2. Most fan wobble problems are caused when
blade levels are unequal. Check this level by
selecting a point on the ceiling above the tip
of one of the blades. Measure from a point
on the center of each blade to the point on the
ceiling. Measure this distance as shown in
Figure 15. Rotate the fan until the next blade
is postioned for measurement. Repeat for
each blade. Measurement deviations should
within 1/8". Run the fan for 10 minutes.
3. If the fan continues to wobble please contact
Customer Service and a balacing kit will be
sent to you at no charge.
Figure 15
9.