Whirlpool WRX988SIB Manual De Instrucciones

Cabinet
Not Including
Handle
Including
Handle
Top of
Cabinet
Model Size Height Overall Height - Top of
"A" Cabinet
WRX988SIB 70 / " (1781 mm) 68 / " (1743 mm)
1 5
8 8
WRX986SIH 70 1 / " (1781 mm) 68 3 / " (1746 mm)
8 4
ELECTRICAL REQUIREMENTS
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Depth - Door Depth - Drawer
Open 90° Open
"B" "C" "D"
48" (1219 mm) 47 / " (1210 mm)
5
8
48 5 / " (1235 mm) 47 5 / " (1210 mm)
8 8
Bottom Mount Refrigerator
Overall
Height
Depth - With Depth - Without
Handles Handles
"E" "F"
35 / " (906 mm) 33 / " (843 mm)
11 3
16 16
36 3 / " (924 mm) 33 3 / " (847 mm)
8 4
Electrical: A 115 V, 60 Hz., AC only, 15 A or 20 A fused, grounded electrical supply
is required. It is recommended that a separate circuit serving only your refrigerator
be provided. Use an outlet that cannot be turned off by a switch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or removing a light
bulb, turn the control (Thermostat, Refrigerator or Freezer Control depending on
the model) to OFF and then disconnect the refrigerator from the electrical source.
When you are finished, reconnect the refrigerator to the electrical source and reset
the control (Thermostat, Refrigerator or Freezer Control depending on the model)
to the desired setting. See "Using the Controls."
Water: A cold water supply with water pressure between 35 psi and 120 psi
(241 kPa and 827 kPa) is required to operate ice maker and water dispenser. If
you have questions about your water pressure, call a licensed, qualified plumber.
IMPORTANT: The pressure of the water coming out of a reverse osmosis system
going to the water inlet valve of the refrigerator needs to be between 35 psi and
120 psi (241 kPa and 827 kPa).
Reverse Osmosis Water Supply: If a reverse osmosis water filtration system is
connected to your cold water supply, the water pressure to the reverse osmosis
system needs to be a minimum of 40 psi to 60 psi (276 kPa to 414 kPa)
1
Depth - Cabinet Width - Cabinet
Only "H"
"G"
28 / " (735 mm) 35 / " (906 mm) 38
15 11
16 16
29" (737 mm) 35 3 / " (908 mm) 38
4
Width - Door
Open 90°
"I"
/ " (970 mm)
3
16
3 / " (970 mm)
16