Machine Positioning - CIBIN Alaska Manual

1.2.2 MACHINE POSITIONING

For a correct operation of the machine, we recommend, when positioning the machine, that you:
- Position the machine in an easily accessible place, in order to facilitate inspections and maintenance operations (Fig.1.2.2.a).
- Position the machine in this part, where the most uniform cold distribution is possible.
- Ensure that the spaces around the air suction and exhaust grids of the machine are not blocked or reduced in size in any way
(Fig.1.2.2.b).
CAUTION: care must be taken when using the machine unit at altitudes of over 1000 m above sea level.
We recommend, during the installation phase, that you don't tilt the machine too far, in order to avoid the spilling of oil from the
compressor into the refrigerating circuit what damages the compressor. As a precaution, we recommend that you leave the unit
switched off for several hours, in order to avoid any possible problems.
WARNING! Position the cart horizontally to censure the proper functioning of the monobloc!
= =
Fig.1.2.2.a
WARNING!! The monobloc should be positioned in the cold room by a qualified technician and following the sequence
(A....G) given below.
Tools required are as follows: -hand saw; 13 mm wrench -drill.
A) BLOCK the cart/cold room to lodge the monobloc cor-
rectly with the brake and wedges on the wheels.
B) DRILL a hole in the ceiling of the cold room. Follow the
indications provided in the diagram and glue the supplied
gasket around the edge of the hole without clogging the faste-
ning holes (Fig.1.2.2.c and enclosures).
= =
=
=
500mm
500mm
500mm
Fig.1.2.2.b
Fig.1.2.2.c
70
500mm
1000mm
500mm