Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Indoor Wireless Remote Control Outlet
WARNING:
Danger of explosion if battery is incorrectly replaced. When replacing battery,
replace it with the same or equivalent type CR2032. Observe correct polarity (+ and –) when
replacing batteries. Do not store or carry batteries so that metal objects can contact exposed
battery terminals.
DANGER:
DO NOT INGEST BATTERY; CHEMICAL BURN HAZARD. This product contains
a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close
securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
1. Step A: Locate the battery compartment on the back
of the remote.
Push down and away to slide the compartment
cover off.
Step B: Remove the plastic battery tab from the battery
compartment in the back of the remote control
to activate the pre-installed battery.
Step C: Slide the compartment cover on the remote
and click securely into place. Your remote is
now ready to use.
2
2.
Plug the receiver into a standard
AC electrical wall socket.
Plug the appliance into the receiver
outlet.
Specifications:
Power input: 125V/60Hz
Power output: 1250W/10A (Max.)
Transmitter frequency: 433.92MHz
Remote transmitter battery: DC CR2032, 3V battery 1pc
Transmission range: up to 100ft
1
3
ON
OFF
3.
To manually control the outlet, press the
ON or OFF button on the remote control.
Once completed, you can then use the
remote control to turn the connected
outlet ON/OFF.
4
Publicidad
Tabla de contenido
