Conairphone SW2505 Manual De Instrucciones página 2

All manuals and user guides at all-guides.com
®
GET TO KNOW YOUR METROPOLIS CONAIRPHONE
PREPARATION
First carefully remove your CONAIRPHONE TM
the handset and telephone base, each carton contains the following accessories:
• One ten (10) ft. fully modular coil cord
• One seven (7) ft. fully modular telephone line cord.
• Owner's Manual
• One (1) Important Notice
• One (1) additional Telephone Number Insert
Important Notice
Your CONAIRPHONE TM will operate on all systems, true tone or rotary.
1. If your home is wired for rotary service, move switch to pulse position (P).
2. If your home is wired for tone service, move switch to tone position (T).
3. If you are unsure of the type of service you have, ask your local telephone company.
3
TM
Diagram A
from the unit carton. In addition to
Pushbutton Dialing Convenience on Rotary Lines
This phone can be used as a direct replacement for rotary service. If your home
is wired for rotary service, move switch to pulse position and enjoy pushbutton
dialing ease.
NOTE : Your telephone will pulse for a second or two while you are dialing. This
simulates the dialing action.
True Tone Dialing
If your home is wired for tone service, move switch to tone position. This can be
used as a direct replacement for tone phones including AT&T's Touch Tone
Series. Also allows use of long distance dialing services and tone accessed
computers.
NOTE : If your home is not wired for tone service, you will not be able to make
outgoing calls while in the tone mode. You have rotary service.
INSTALLATION
Line Cord Connection
With modular jack telephone system connect the straight telephone line cord to
the modular jack located on the back of the base. Insert the other end of cord into
a modular wall jack. Make sure all plugs snap firmly in place (see Diagram B).
With a four prong style jack, simply use a plug in modular adapter (see Diagram C).
Coil Cord Connection
Insert the coil cord by plugging longer straight end into the modular jack on the
side of the base. Connect the other end into the modular jack located on handset
(see Diagram D).
Telephone Number Insert
An area for your phone number has been provided on the reverse side of the
Metropolis ® logo located in the center of the dial key area. Remove the plastic
window, write your phone number on the label and replace it. Slightly bend the
plastic cover to slip back into position.
4
®
Diagram B
Diagram C
Diagram D