Ryobi P770 Manual De Instrucciones

18 VOLT WET/DRY VAC
ASPIRATEUR SEC/HUMIDE EAU DE 18 V
ASPIRADORA EN HÚMEDO/SECO DE 18 V
P770/P770ID
NOTE: These instructions supplement the WET/DRY VAC ASSEMBLY
instructions located in your operator's manual. For complete assembly
instructions, refer to page 5 of the Operator's Manual.
WARNING:
This insert sheet is not a substitute for reading the operator's manual.
To reduce the risk of injury or death, user must read and understand
operator's manual before using this product.
ONE WORLD TECHNOLOGIES, INC.
P.O. Box 1288, Anderson, SC 29622 • Phone 1-800-525-2579
États-Unis, Téléphone 1-800-525-2579 • USA, Teléfono 1-800-525-2579
www.ryobitools.com
998000221
4-17-20 (REV:02)
ATTENTION
Your vacuum requires some assembly.
If after you have installed the float, your vacuum
does not turn on, please check the following:
1. Arrows on the float and underside of the lid
are lined up.
2. Float screws are tightened until you hear a
CLICK.
Please do not return to store.
For additional assistance:
Call 1-800-525-2579
Or, scan the QR code below for a video.
Scan the QR code for a link to the installation video.
Balayer le code QR pour un lien vers une vidéo d'in-
stallation.
Escanee el código QR para obtener un vínculo al video
de instalación.