Pre-Dialing - Microsonic TEL8021S Manual Del Usuario

Maximum 4 bases can be linked to the same handset by the follow ways:
1. In standby mode, press MENU key, then using
2. Press MENU key to enter. Press
3. Press MENU key to confirm, LCD displays PIN? Then enter the pin code (defaulted as 0000, if input
wrong number, press R/C to delete).
4. When finished press MENU key to confirm. LCD display SEARCHING, then press and hold
until you has get DI-DU- DU- sound. The handset and base have registration successfully.
Notes:
1. If the handset and base is fail to registration successfully, the handset will return to the standby mode.
2. You can repeat the above steps to register another handset for the same base, and the successfully
registered handset will displays HS2 or HS3 on the LCD according to the registration sequence.
3. Press key to page the handset when difficult to look for.
OPERATION
Handset and hands-free mode
Press key once to obtain a dial tone, dial your number, when you hear the called party answers the
phone, you can begin your conversation.
During the conversation, press
Hands-free and handset volume control
During handset mode, press
During hands-free mode, press
Mute the speakerphone
During a call, press MENU key once to mute the mouthpiece and MUTE will show on LCD. Press MENU
key again to get back to the call and the MUTE will disappear.
Caller ID – type I & II
TYPE I
After you have applied the caller ID service, you can see the caller phone number during an incoming ring.
TYPE II
During the conversation, the phone number of the incoming call of the second caller can be seen in the unit.
This function can be worked when the user applied the Telecom service.
Auto timer
The timer will start automatically after 6s of the telephone line is engaged.
Flash
When dial a number and the line is busy, press R/C and RD/P key to dial it out again.
Pause
Press RD/P key will insert a time delay of 3.6 seconds in a dialing sequence.

Pre-dialing

The unit has pre-dialing function, when you may enter and edit the number before dial it out.
The following procedure describes how to use this function:
or key to select BASE from BASE1, BASE2, BASE3 or BASE 4.
key to transfer the conversation mode between handset and hands-free.
or key to adjust the handset volume. There are 5 levels for selection.
or key to adjust the speaker volume. There are 6 levels for selection.
or key to select REGISTERATION item.
30
key