Courtyard Creations XTM011X Instrucciones De Armado

ASSEMBLY INSTRUCTIONS
ATTENTION: THIS PRODUCT IS NOT FOR COMMERCIAL USE
PARTS LIST
PART
MATERIAL CODE
NO.
1
XTM011X-CS04-4
2
XTM011X-CS04-3
3
62XTM011XQ101
4
XTM011X-CS02-1
5
17C02A0712003YX
Attention:
Make sure that each bolt needed for all steps matches
the corresponding figure to ensure proper assembly.
Step 1:
Fasten the braces (#3) to the right and left legs (#1 and
#2). Fasten them by using steel washers (#7) and bolts
(#5). See Figure 1.
Note:
The labels marked "L" and "R" on the legs (#1 and #2)
should coincide with Figure 1 to ensure proper assembly.
Use the correct bolts as indicated. Do not tighten any of the bolts until the ottoman is completely assembled.
!
Do not discard of any of the packaging until you have checked that you have all of the parts and fittings required.
!
Keep children away during assembly. This item contains small parts that can be swallowed by children.
!
Children should always be under direct adult supervision while using this product.
Retain these assembly instructions for future reference.
!
Quote the following FQC NO. when contacting the service center.
!
V-3
INTENDED FOR RESIDENTIAL USE ONLY.
XTM011X
PART Q'TY
RIGHT LEG
LEFT LEG
BRACE
SEAT ASSEMBLY
BOLT M6*35
SERVICE CENTER TOLL FREE NO.
TEL: 1-877-539-7436
FAX: 1-877-539-7439
DO NOT RETURN TO THE STORE!
STOP
PAGE 1 OF 2
PART
MATERIAL CODE
NO.
1 6
17C40A0712001YX
1 7
17XA3309
2 8
17KAA0201----Y4
1 9
17KAA0101----Y4
4 10
17KAC3101----Y3
FIGURE 1
R
3
#5 BOLT M6*35
PART
BOLT M6*35
STEEL WASHER
HEX. KEY WRENCH 6MM
HEX. KEY WRENCH 4MM
HEX. KEY WRENCH 10MM
1
3
2
L
COURTYARD CREATIONS INC.
Q'TY
4
4
1
1
1
7
5
35