Oase AquaMax Eco Titanium 50000 Instrucciones De Uso página 16

Ocultar thumbs Ver también para AquaMax Eco Titanium 50000:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
- EN -
Submerged installation of the pump
Attention! Rapidly rotating impeller unit.
Possible consequences: Severe injuries due to amputation of limbs.
Protective measures:
 Place the pump in a pump chamber and screw the contact guard (accessory, article No. 43329) onto the
suction socket.
 Place the pump in a pump chamber and protect the pump chamber against unauthorised access (use a
padlock or screws to secure the access).
 D, E
 Never operate the pump in a swimming pond.
 Swimming pond or pool that may be accessed by people.
– Install the unit at least 2 m away from the water.
 Only operate the pump when it is below the water surface level.
 Place the pump with stand in a horizontal position on a suitable base. Bolt the stand to the base.
 Screw a DN 75 pipe onto the outlet.
 Protect the pump inlet against unforeseeable reaching in:
– Screw a contact guard (accessory, article No. 43329) onto the inlet or
– protect the pump chamber against unauthorised access (use a padlock or screws to secure the access).
 The position of the pump outlet can be changed. The pump casing has to be turned to achieve a different position.
Install the unit at a dry place
 D, F
 Swimming pond or pool that may be accessed by people.
– Install the unit at least 2 m away from the water.
 Do not expose the unit to direct sunlight.
 Place the pump in a horizontal position on a suitable base and bolt down.
 Screw a DN 75 pipe onto the inlet and outlet.
 The position of the pump outlet can be changed. The pump casing has to be turned to achieve a different position.
Fitting connections
How to proceed:
 F
Remove the protection cap.
Fit DN 75 pipes.
Turning the pump casing to achieve a different position
How to proceed:
 G
Remove the screws and remove the pump from the stand.
Remove the four screws and take off the pump casing.
Turn the pump casing, place it onto the motor and fasten with the four screws.
Place the pump on the stand and fasten with the screws.
16

Publicidad

Tabla de contenido
loading

Tabla de contenido