REMEHA Celcia 20 Guía De Funciones página 12

9 BOOSTER FUNCTION FOR ROOM-CONTROLLED HEATING
A booster function allows for accelerated heating up,
following in increase of the set temperature. Should this
lead to problems (skyrocketing temperature levels), the
booster function may be shut off. The booster function is
activated at delivery.
Set the rotary knob on MENU
§
Go to the SETTINGS option and press OK
§
Go to the CONTROLLER option and press OK
§
10 REMAIN SETTINGS
10.1 Pin code
To change the room temperature setpoint with a
(mobile) telephone, you need, apart from the Celcia
Gateway, a special code. This code has 4 digits:
Set the rotary knob on MENU
§
Go to the SETTINGS option and press OK
§
Go to the MISCELLENEOUS option and press OK
§
Go to PIN CODE and press OK
§
Set the required value and select OK
§
Return the rotary knob to the desired programme
§
and close the lid.
10.2 Setting the desired hot-water temperature
With Celcia 20 you can set the hot-water temperature
of the combi-boiler or hot-water storage heater
temperature has priority over the temperature setting in
the boiler. Change the temperature as follows:
Set the rotary knob on MENU
§
Go to SETTINGS and press OK
§
Select CONTOLLER and press OK
§
Go to DHW TEMP
§
Set the required value and select OK
§
Return the rotary knob to the desired programme
§
and close the lid.
only if a sensor is fitted
*)
10.3 Maximum pre-heating time
The "automatic pre-heating" function ensures that the
room is at the required temperature at the programmed
moment. So in cold periods the boiler will start heating
earlier than in warm periods. Celcia 20 automatically
calculates how much earlier the boiler has to start
heating. The "Maximum pre-heating time" setting can
be used to limit this time or deactivate the function
completely (in that case, set the value at 0). Note: If you
do so, it may not be warm on time.
Set the rotary knob on MENU
§
Go to SETTINGS and press OK
§
Select CONTROLLER and press OK
§
Go to PRE HEAT and press OK
§
Set the required time and select OK
§
Return the rotary knob to the desired programme
§
and close the lid.
Go to BOOSTER and press OK
§
Select YES or NO and select OK
§
Return the rotary knob to the desired programme
§
and close the lid.
10.4 Legionella
To prevent Legionella growth, it is good to warm up a
calorifier once a week. The Legionella function in Celcia
20 warms up a calorifier every Monday between 0:00
and 03:00 to 65°C. This functions only when a calorifier
sensor is mounted and not with a thermostat.
To switch on/off
Set the rotary knob on MENU
§
Go to SETTINGS and press OK
§
Select CONTROLLER and press OK
§
Go to LEGIONEL and press OK
§
Select YES or NO and press OK
§
Return the rotary knob to the desired programme
§
. This and close the lid.
*)
10.5 Counters reset
Resetting the Celcia Gateway hor counters and boiler
starts can be achieved by entering the PIN-code 0012
(see par.10.1). Then turn Celcia 20 rotary knob to
"MENU" and push " info-button i repeatedly until the
function "RST COUN NO/YES" appears. Confirm with
OK.
Don't forget to reset the de PIN-code to the set value.
12
Remeha Celcia 20