Phoenix FS0440F Guia De Inicio Rapido

Memory Button
Door back or Top drawer back
FIRST OPENING ON FACTORY DEFAULT CODE
Factory code is 1 2 3 4 5 6
1. Touch the screen, to activate (1 bleep and screen illuminates).
2. Enter the user code (1st time usage 123456).
3. Touch OPEN, a melodic tone will sound and the display will show
OPEnd.
4. Turn handle clockwise and open the door while the tone is sounding.
CAUTION
I. If an incorrect code is entered, Error will appear in the display panel
and a short warning tone will sound.
II. If a wrong code is entered 5 times the lock will cease to operate for 5
minutes. During which a warning tone will sound and the display will
indicate deLAY.
SETTING A NEW USER CODE
Set a new code with the door open and test the new code before closing
the door.
1. Touch the screen to activate
2. Touch ENTER
3. Type in the present code
4. Touch ENTER
5. Type in the new 4 – 16 digit code
6. Touch ENTER, a melodic tone will sound and the display will show
EntErd
For example:
If the present code is 1 2 3 4 5 6 and a new four digit code is decided as 4
2 4 2 enter the following –
ENTER > 1 2 3 4 5 6 > ENTER > 4 2 4 2 > ENTER
EntErd will show in the display and a short tone will sound to confirm the
change to 4 2 4 2
INTRODUCING A FINGERPRINT
Open the door using the user code. Keep the door open while
carrying out this process.
FS0440F OPERATING INSTRUCTIONS
& GUARANTEE REGISTRATION
Upper part
Reset Button
Phoenix Safe Company where peace mind is guaranteed
Lower part
Battery Case
Hold the upper part and turn it counter-clockwise to
disassemble (1,5V AA Alkaline 4 pcs)
1. Press the M button on the back of door, the screen will be activated
2. Press 3 on the screen
3. Press ENTER
4. Enter the user code and press ENTER
5. Scan in the fingerprint twice consecutively, by placing the finger on the
sensor. The screen will show EntErd a melody will sound.
NOTE: Check the finger print had been set correctly following - How
to open with a fingerprint.
• A total of 128 finger prints can be
introduced into the lock.
HOW TO OPEN WITH A
FINGERPRINT
1. Touch the screen to activate
2. Scan the fingerprint on the sensor,
the screen will show OPEnd and a
melody will sound.
3. Turn the handle clockwise and open
the door while the tone is sounding.
CAUTION
I. If an incorrect fingerprint is scanned, ErrOr will appear in the display
and a short warning tone will sound.
II. If a wrong fingerprint is scanned 5 times the lock will cease to operate
for 5 minutes. During which a warning tone will sound and the display
will indicate deLAY.
HOW TO DELETE REGISTERED FINGERPRINTS
1. Press the M button on the back of the door, the screen will be
activated.
2. Press ENTER
3. Press 3
4. Press ENTER, the display will show CLEAr and a melody will sound.
NOTE: All fingerprints are deleted
Upper
part
Lower
part
Securing
Hole
Put Finger-print twice
While red lamp flickering,
1
put user's finger on sensor.
After Bi- sound,
2
1
repeat the above
V1 JUL 2018