SEVERIN HS 0706 Instrucciones De Uso página 13

can be variably adjusted.
– A scale for the cutting lengths adjustment is
indicated on the rear of the trimming head.
The arrow markings on the push-on combs
correspond with the cutting length on the
scale.
– In its lowest position, the cutting length of
the 4-20 mm push-on comb is 4 mm, and
24 mm on the 24-40 mm push-on comb.
– Fit the desired push-on comb, select the
appropriate cutting length at the rear and
release the locking buttons to ensure that
the push-on comb locks into place.
– When cutting hair, always start with a longer
cutting length and reduce it gradually until
the desired length has been reached.
Using the main power switch ( ) to turn
the trimmer on
Use the main power switch to turn the
appliance on. The motor starts running and
the touch controls light up. Push the main
power switch again briefl y to turn the appliance
off again.
Using the touch controls ( / ) to turn
the trimmer on/off
– Once the trimmer has been turned on with
the main power switch, it may be switched
off, or on again, by using the touch controls.
By sliding the fi nger rapidly from
the trimmer is turned off and remains in
standby mode. It can be switched on again
by doing the reverse, from
– After two minutes in standby mode, the
trimmer switches off automatically.
Adjusting the operating speed:
– The operating speed can be adjusted:
keeping the touch control pressed
decreases the speed, while keeping the
touch control pressed increases it. Two
short beeps indicate that the min or max
speed settings have been reached. The
selected setting is saved during standby
mode.
Locking the sensor touch controls
To prevent accidentally changing the desired
settings during use, the sensor touch controls
may be locked for the duration: simply keep
the main power switch pressed for 2 seconds.
While locked, the touch controls are only faintly
illuminated. To cancel the locking function,
keep the main power switch pressed again for
2 seconds. This function cannot be used while
the appliance is in stand-by mode.
Cutting/thinning function
The cutting/thinning selector switch allows
selecting between cutting and thinning of hair.
For cutting, select the switch setting 'CUT'. If a
trendy short-hair style should require that the
hair is thinned by about one third, select the
setting 'THIN'. In this mode, always cut the hair
against its natural direction of growth.
Operation
 Before each use, always put a few drops
Cutting hair:
– For longer hair, one of the push-on combs
– Switch the appliance on.
to , – The hair should fi rst be combed, and then
– Always cut from bottom to top with the
to .
– For a shaped cut, reverse the appliance and
Care and Cleaning
 It is essential to switch off the appliance
13
of acid-free oil between the trimming comb
and the blade.
provided may be used. We recommend that
you start with the large comb.
generally cut against its natural direction.
shaving head lying against the head; lead
the appliance upwards through the hair,
moving it gradually away from the head at
the same time
shorten the hair from top to bottom without
a push-on comb.
and then remove the adaptor from the wall
socket before cleaning and oiling. To avoid
the risk of electric shock, the appliance and
the adaptor must not be immersed in liquid