AmerTac TM15DOLB Manual De Instrucciones Y Garantía

TM15DOLB
Instruction Manual & Warranty
2-Outlet Outdoor Digital Timer
Getting Started
NOTE: Before first use, remove the plastic protective tab in the battery
compartment.
When turned on, the display will read as shown in Figure 1.
Setting Current Time
Press and hold CLOCK button during entire process.
Press HOUR button to advance the hours.
Press MIN button to advance the minutes.
Press DAY button to advance the day.
Setting Programs
Press PROG button once. Display will look as shown in Figure 2.
The number "1" in the lower left hand corner indicates you are
programming EVENT 1. Press DAY button repeatedly until the display
shows the day you want timer to turn on.
Options Include
All days of the week: MO, TU, WE, TH, FR, SA, SU
Individual days of the week: MO, etc
Weekdays only: MO, TU, WE, TH, FR
Weekends only: SA, SU
Press HOUR and MIN buttons to set time for device to turn off
for EVENT 1. Repeat ON/OFF program procedures outlined above for
each event (up to seven events) as needed.
When finished, press CLOCK button to return to current time display.
Reviewing Event Programming
In current time display, press PROG button repeatedly to check settings.
When finished, press CLOCK to return to current time display.
Setting Mode
The Mode acts as an ON/OFF override or sets the events to
Automatic or Random.
To override current program (ON/OFF), press MODE button once.
To override current program (Automatic), press MODE button once.
To run events in a Random mode (ON/OFF is + / – 30 minutes of programmed
times), press MODE button until RDM is displayed in the upper left
hand corner.
The Random mode is a security feature that will give your home a
more lived-in look.
Installing Timer
Plug timer into AC outlet. Plug lamp(s) or other device(s) to be controlled
into receptacle(s) at bottom of timer.
All manuals and user guides at all-guides.com
Figure 1
Figure 2
Backup Battery Replacement
Timer runs on one AA battery when not connected to AC power.
To remove battery, unscrew battery door using a Phillips head screwdriver.
Remove battery and replace with new AA battery.
Tightly screw battery door in place.
Battery is designed to save settings in the event of a power outage.
Battery will not provide power to devices plugged into timer.
Specifications:
120V~, 60Hz
15A, 1800W General Purpose
8.3A, 1000W Tungsten
0.25HP Motor
Limited One Year Warranty
AmerTac™ warrants this product to be free from defects in material
and workmanship for a period of one year from the date of purchase.
AmerTac's obligations are limited to repairing or replacing any defective
unit and are effective only if such units are returned within one year
of the purchase date to AmerTac, 250 Boulder Drive, Breinigsville, PA
18031. Warranty void if damage is due to misuse or improper installation.
In no circumstance will AmerTac be liable for consequential or incidental
damages relating in any way to this product.
Questions?, ¿Preguntas? 201.661.9945
©2011 AmerTac™
Saddle River Executive Centre,
One Route 17 South, Saddle River, NJ 07458
www.amertac.com
Made in China
MO
AM
OFF
MO TU WE TH FR SA SU
ON