Package Contents; Assembly And Adjustments - DeWalt DE0892 Manual Del Usuario

EN G LI SH
• Always insert batteries correctly with
regard to polarity (+ and –), marked
on the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new batteries.
Replace all of them at the same time
with new batteries of the same brand
and type.
• Remove dead batteries immediately
and dispose of per local codes.
• Do not dispose of batteries in fire.
• Keep batteries out of reach of
children.
• Remove batteries if the device will
not be used for several months.

Package Contents

The package contains:
1 Digital laser detector
1 Clamp
1 Battery
1 Instruction manual
• Check for damage to the tool, parts or
accessories which may have occurred during
transport.
• Take the time to thoroughly read and
understand this manual prior to operation.
Description (fig. 1, 2)
WARNING: Never modify this
attachment or any part of it. Damage or
personal injury could result.
a. LCD display window
b. Speaker
c. Battery compartment cover
d. Marking notches
e. Power button
f. Volume button
g. Accuracy button
h. Magnets
i. Sensor window
j. Clamp latch
k. Tracks
14
l. Rail
m. Latch
n. Latch hole
o. Clamp knob
The detector gives both visual signals through the
LCD display window (a) and audio signals through
the speaker (b) to indicate the location of the laser
beam.
The D WALT Digital Laser Detector can be used
e
with or without the detector clamp. When used
with the clamp, the detector can be positioned on a
grade rod, leveling pole, stud or post.
INTENDED USE
The D WALT Digital Laser Detector helps in locating
e
a laser beam emitted by the laser in bright light
conditions or over long distances. The detector can
be used in both indoor and outdoor situations where
it is difficult to see the laser beam.
The detector is designed exclusively for use with
the DW088, DW089, DW0811, DW0822, DW0851
DCE088R/G; DCE089R/G; DCE0811R/G (Line) line
laser and other compatible D
not for use with rotating lasers.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
The digital laser detector is a professional laser
accessory.
DO NOT let children come into contact with the
attachment and laser. Supervision is required when
inexperienced operators use this laser.

ASSEMBLY AND ADJUSTMENTS

WARNING: Refer to the manual of the
tool to be used with this attachment.
Batteries (fig. 1)
The digital laser detector is powered by a 9-volt
battery. To install the battery provided, lift up on the
battery compartment cover (c). Place the 9-volt
battery in the compartment, aligning the battery as
shown on the embossed icon.
Detector Controls (fig. 1)
The detector is controlled by the power button (e)
and the volume button (f).
When the power button is pushed once, the
detector is turned on. The top of the sensor window
shows the ON icon and the volume icon.
WALT line lasers. It is
E