Uline S-14527 Guia De Inicio Rapido

S-14527, S-14528
COUNTERTOP
PROTECTION TAPE
The manufacturer and distributor warrant that
this product is free from defects in material and
workmanship under normal use in accordance with their
instructions and specifications. Their sole responsibility
for any breach in this warranty is to replace that
quantity of the product not conforming to such
warranty. The customer is required to provide prompt
written notification to the manufacturer or distributor of
any defect covered by this warranty. Return or other
disposition of defective material will then be authorized.
There are many variations in countertop surfaces
which make it imperative that the user of this product
determines its suitability. Special attention must be given
to newly stained, top coated, finished or refinished
countertops.
1. Test the countertop protection film on a small
inconspicuous area.
2. Leave in place for 48 hours and then inspect to
ensure there is no change to the countertop.
NOTE: This product is used for temporary
surface protection during painting, remodeling,
relocations or construction.
PAGE 1 OF 3
1-800-295-5510
uline.com
IMPORTANT INFORMATION
The manufacturer and distributor assume no
responsibility for any loss or damage caused by:
(1) any modification made to the product, (2) use of a
version of the product that has been previously used or
reconditioned, or (3) the use of the product in a manner
inconsistent with the manufacturer's or distributor's
applicable instructions and specifications.
The warranty given hereunder is limited, and is given
in lieu of any other express or implied conditions and
warranties, including those implied by applicable law or
merchantability, fitness for a particular purpose or use,
and all such other conditions and warranties are hereby
disclaimed.
APPLICATION INSTRUCTIONS
Application can be made easier by locating the tab at
the beginning of the roll. For best results, clean and dry
countertop surface prior to application.
1.
2. Pull the roll over the desired coverage area.
3. Apply pressure to the covered area to ensure the
Store this product in a dry place, not to exceed
+100° or -40°F (+38° or -4°C).
Pour le français, consulter la page 3.
NOTE: The temporary usage period should
not exceed 30 days. This product is not
recommended for use in high humidity areas
or for outdoor use.
Pull the first few inches of the film and press to the
surface.
protective film remains in place.
Para Español, vea página 2.
0521 IS-14527