Descargar Imprimir esta página

Uline S-10479 Guia De Inicio Rapido página 2

Respirador estandar con valvula

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Stretch and pull the lower
headband over the
head and position below
your ears. Stretch and
pull the top headband
on the back of your
head above your ears.
(See Figure 3)
4. Press soft metal
nosepiece to conform
snugly around the nose.
(See Figure 4)
• This product does not eliminate the risk of
contracting any disease or infection.
• Failure to follow all instructions and limitations on the
use of this product could reduce the effectiveness of
respirator and result in sickness or death.
• Before occupational use of this respirator, a
written respiratory protection program shall be
implemented meeting all requirements of OSHA 29
CFR 1910.134 such as training, fit testing, medical
evaluation, and the applicable OSHA's substance
specific standards.
• This product does not supply oxygen. Use only in
adequately ventilated areas containing sufficient
oxygen to support life. Do not use this respirator
when oxygen concentration is less than 19.5%.
• Do not use when concentrations of contaminants
are immediately dangerous to health or life.
PAGE 2 OF 6
FITTING INSTRUCTIONS CONTINUED
Figure 3
Figure 4
SAFETY
1-800-295-5510
uline.com
5. To test fit, cup both
hands over the respirator
and inhale sharply. A
negative pressure should
be felt inside respirator.
If air flows around
your nose, tighten the
nosepiece. If air leaks
around the edges,
reposition the headband
for better fit. (See Figure 5)
6. Change respirator immediately if breathing
becomes difficult or respirator becomes
damaged or distorted, or a proper face fit can
not be maintained. Careful observance of these
instructions is an important step in safe respirator use.
• Leave work area immediately and return to fresh air
if breathing becomes difficult, or dizziness or other
distress occurs.
• Facial hairs or beards and certain facial
characteristics may reduce the effectiveness of this
respirator.
• Never alter or modify this respirator in any way.
• Only for single use. No maintenance necessary.
Discard the used respirator after single use.
• Keep respirators in the display box away from direct
sunlight until use.
• Special Instructions: The model S-10479 filtering
facepiece respirator has been manufactured by
San Huei United Co., Ltd. for ULINE under NIOSH
TC-84A-3714.
Figure 5
0621 IS-10479

Publicidad

loading