GreenWorks Commercial GE 080 Manual Del Propietário página 14

OPERATION
REPLACING THE BLADE (See Figure 7.)
If the blade worn out, replace it with a new one (not provided) produced by Greenworks.
• Remove the battery pack.
• Use a metal rod (1) (provided) to fix the blade.
• Remove the screw (2) clockwise with the wrench provided.
• Remove the washer (3).
• Remove the old blade and replace it with a new one.
• Place the washer (3) on the blade.
• Place the screw on the washer and tighten it unclockwise with the wrench provided.
OPERATING THE EDGER
W A R N I N G
Always hold the edger away from the body keeping clearance between your body and the edger.
Any contact with the edger cutting head while operating can result in serious personal injury.
• Hold the edger with your right hand on the rear handle and your left hand on the front handle.
• Keep a firm grip with both hands while in operation.
• Edger should be held at a comfortable position with the rear handle about hip height.
• The edger will edge along sidewalks, driveways, flower beds, curbs, and similar areas.
• Cut at a steady pace. If the blade begins to bog down, you are edging too fast; slow your pace. Do
not force the blade into ground.
• Light contact of the blade against the sidewalk edge, curb, etc., is acceptable and will not damage
the edger.
• Best appearance is obtained when grass is dry. Avoid edging in wet soil or wet grass areas or the
blade guard might clog and result in an uneven edge. If the blade guard becomes clogged, stop
the edger, remove the battery, and remove debris from the blade guard.
2
3
1
14
TIGHTEN
LOOSEN
Fig. 7