goliath G-AC004 Manual Del Usuario

EN
GOLIATH G-AC004
USER'S MANUAL
REAR TRAY FOR GOLIATH PRO+
* This tray is designed to be mounted exclusively on the GOLIATH PRO+
electrical repair stand.
WHAT YOU WILL FIND IN THE BOX:
1 metal rear tray for GOLIATH PRO stand
2 x 5mm Allen screws to x the tray to the stand
CHARACTERISTICS AND USE:
The rear tray was designed as a surface to accommodate small parts, tools or a
magnetic tray during the repair or maintenance work of a bicycle, since part of these
occurs through the rear of the repair stand.
It is a robust tray made entirely of steel.
The G-AC004 tray is prepared to house various accessories, such as the R-AC001
multifunctional wheelwork stand or the G-AC002 air kit.
ASSEMBLY INSTRUCTIONS:
MOUNTING THE TRAY ON THE GOLIATH PRO STAND:
1- Take the tray out of the box.
2- The GOLIATH PRO stand is prepared to house the tray with two holes in the lower
left part of the main housing. (Photo 1)
You must place the tray through the holes with the attached screws upwards so that it
is at the back of the support.
3- Tighten the screws until the tray is xed and solidly mounted to the support.
WARNINGS OF DANGER IN THE USE OF THE G-AC004 TRAY:
1- Do not load more than 1Kg in the tray
2- The tray G-AC004 must not be handled by children.
MAINTENANCE:
The tray does not require any speci c maintenance.
Photo 1